Abstract:Cooling performance experiments for turbine blades are increasingly being conducted at low temperature and pressure in order to reduce the cost and difficulty of the experiments. However, the lack of similarity between scaling and real engine conditions leads to deviations in the experimental results. The application of a suitable scaling criterion can significantly reduce this deviation and promote the engineering of scaling experiments. This study explores a suitable criterion for scaling of film cooling when the coolant to mainstream temperature ratio for scaling conditions deviates from the datum condition, taking the 1st stage stator from the E-3 aero engine as an example. This study focuses on the pressure side of the blade. The effect of the coolant to mainstream temperature ratio on the pressure side film cooling effectiveness was initially investigated based on both numerical and experimental methods. The scaling accuracy of six criteria was then compared based on numerical results, followed by an analysis of the reason leading to the scaling deviation. In our study the datum condition was selected to have an inlet pressure and inlet temperature of 1861 kPa and 1543 K, respectively. This operating condition corresponds to that of a real engine. Finally, the results obtained from the numerical method are validated experimentally. Both the numerical and experimental results indicate that the film cooling effectiveness on the pressure side decreases with an increase in the temperature ratio at low temperature ratio conditions, while the trend reverses at relatively high temperature ratio conditions. We found that the M criterion is suitable for scaling the downstream region of-60 % l/l(0) (the downstream region of the last cooling hole row), while the most accurate scaling results in the region from the leading edge to-60 % l/l(0) (the region with dense film cooling holes) can be obtained by applying the I criterion. The region near the leading edge (around cooling hole row 1) is difficult to scale. This is because the separation in the downstream region of cooling hole row 1 in the datum condition does not exist in any scaling condition.

Assessment of Scaling Distortion in Condensation Film Heat Transfer

Scaling analysis and design for PCS air flow path natural circulation

Scaling of AP Containment Wall Heat Removal

Investigation of Scale-Up Capability of RELAP5/MOD3 and Scaling Distortion in the IIST Facility Via Natural Circulation Experiments

CFD validation of condensation heat transfer in scaled-down small modular reactor applications, Part 1: Pure steam

Scaling and Distortion Analysis Using a Simple Natural Circulation Loop for FHR Development

Fractional scaling analysis of cladding temperature in large break loss of coolant accident

Fluid-to-fluid Scaling of Heat Transfer in Circular Tubes Cooled with Supercritical Fluids

CMT Scaling Analysis and Distortion Evaluation in Passive Integral Test Facility

Evaluation of Distortion of Wall Stored Energy in Core Make-Up Tank Test Facility

Fluid-to-fluid Scaling of Heat Transfer to Mixed Convection Flow of Supercritical Pressure Fluids

Review, numerical validation, and experiment verification for Definite solution Analogy Theory (DSAT) in thermal-hydraulic scaling

Scaling Criteria Accuracy for Turbine Blade Film Cooling Effectiveness at Unmatched Temperature Ratio Conditions

Improvement of Condensation Model With the Presence of Non-Condensable Gas for Thermal-Hydraulic Analysis in Containment

Scaling for Different Containment Passive Cooling Design under LOCA Conditions

DESIGN AND DISTORTION ANALYSIS OF THERMAL-HYDRAULICS TEST FACILITY FOR THE FUEL TRANSFER TUBE

A New Method on Fluid-to-fluid Scaling for Heat Transfer in Tubes at Supercritical Pressures

Research on Scaling Analysis and Design Parameters of Integral Test Facilities for PWR

Improvement of Diffusion Layer Model for Steam Condensation in the Presence of Non-condensable Gas under Turbulent Free Convection

Analysis of a test facility for transients in a supercritical water-cooled reactor using dynamic system scaling methodology

Scaling Analysis for Convective Heat Transfer in Tube at Supercritical Pressure