Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Theoretical Predictions of Spectral Emissivity for Coal Ash Deposits

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

A general mechanistic model of fly ash formation during pulverized coal combustion

Coal Ash Deposit Normal Spectral Emissivity Measurement

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

A six-parameter model to predict ash formation in a CFB boiler

Prediction of Ash Deposition in a Biomass Boiler Using Thermomechanical Analysis

Semi-empirical Technique for Predicting Ash Size Distribution in CFB Boilers

Simulation of Ash Deposit in A Pulverized Coal-Fired Boiler

An Experimental Investigation into the Characteristics and Deposition Mechanism of High-Viscosity Coal Ash

In Situ Diagnostics on the Dynamic Processes of Ash Deposit Formation, Shedding, and Heat Transfer in a Self-Sustained Down-Fired Furnace

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

Mineral conversion and thermodynamic simulation of ash deposition during Zhundong coal combustion in boiler of thermal power plant

Measurements and Prediction of Ash Deposition in a Cyclone-Fired Boiler Operating under Variable Load Conditions

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

The morphological and mineralogical characteristics and thermal conductivity of ash deposits in a 220 MW CFBB firing Zhundong lignite

Numerical simulation and mathematical models of ash deposition behavior considering particle properties and operating conditions

Ash Deposition of Zhundong Coal in a 350 MW Pulverized Coal Furnace: Influence of Sulfation

Modelling of Fly Ash Viscous Deposition and Slagging Prediction of Biomass-fired Boiler

The Mineralogy Analysis Of Ash Deposition In Refractory Zones In A W-Flame Boiler

Modeling of arsenic migration and emission characteristics in coal-fired power plants