Abstract:Carbon dioxide emissions has become the focus of world attention.In recent years,capture and storage of CO2(CCS) is considered to be a potential technical on reducing CO2 emissions.As a kind of new absorbent,the ammonia solution obtains universal attention.In order to provide reference data to the future industrial design,the absorption of CO2 into aqueous ammonia had been studied in a spray tower at atmospheric pressure.The results show that the higher concentration and flow rate of the aqueous ammonia solution are beneficial to promote CO2 removal efficiency.The volumetric overall mass transfer coefficients of CO2 absorption into aqueous ammonia were measured.It was found that the performance of the spray column varies with the tested process parameters,including ammonia concentration,liquid flow rate,gas flow rate,CO2 concentration in inlet gas and temperature.Experimental results show that the volumetric overall mass transfer coefficients decreases slightly when increasing CO2 inlet concentration.The volumetric overall mass transfer coefficients increases remarkably with the ammonia concentration and also increases with the gas flow rate and liquid flow rate.It was also found that the temperature affects the volumetric overall mass transfer coefficients.When the temperature in the spray tower is lower than 40 ℃,the volumetric overall mass transfer coefficients increases with the temperature.Whereas,when the temperature in the spray tower is higher than 40 ℃,the volumetric overall mass transfer coefficients decreases with the increasing temperature.

Process calculation of mechanical ventilation prilling tower for ammonium nitrate

Development and Application of Industrial PTA Oxidation Process Online Process Calculation

MODELLING AND SIMULATION OF CARBONATION PROCESS OF AMMONIACAL BRINE Ⅱ THE REACTOR/CRYSTALLIZER MODEL OF CARBONATION COLUMNS

Simulation of Mass and Heat Transfer in New Phosphoric Acid Tower with Circular Water Wall(ⅰ)model Development

Process Research and Design Analysis on Single Tower Crystallization Ammonia Desulfurization Process

Factors Affecting Urea Granulation Tower Simplification of Ventilation

Numerical Simulation of Flow Process of Ammonium Persulfate Crystallizer

Study on Dew Point Corrosion and Ammonium Salt Depositing at Low Temperature System of Atmospheric and Vacuum Distillation Unit

Calculation of Partial Molar Volume of Components in Supercritical Ammonia Synthesis System

Experimental and Simulated Study on Mass and Heat Transfer of Falling Film Evaporator for Ammonia-Containing Wastewater

Process Design of Ammonia Separation for Nitrification Control in Aeration Basins at an IKORC’s Oily Wastewater Treatment Unit

Design method for heating towers used in vapor-compression heat pump systems

Influence of Operating Conditions on Ammonium Bisulfate Deposition in the Rotary Air Preheater of Coal-Fired Power Plants

Mitigation of the ammonium salts corrosion in overhead condensing system of crude tower

Technical and Economical Analysis of a Novel Rotary Air Preheater System

Equipment Maintenance and Intermittently Prilling Method for Urea Plant during Operation in Low load

Analysis on the corrosion characteristic and risk in atmospheric tower using Aspen plus software

Mixing Effects on NO Reduction by NH3 at Intermediate and Elevated Temperatures in Flow Reactors

Drop Diameters During Urea Prilling

Volumetric Overall Mass Transfer Coefficients of CO_2 Absorption Into Aqueous Ammonia of Fine Spray

Analysis of Multiphase Flow and Heat and Mass Transfer for Ammonium Chloride Crystallization of the High-Pressure Heat Exchanger in Hydrogenation Unit