Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Progress on Effects of Through-Thickness Normal Stress on Sheet Metal Forming Limit

Effect of Through-Thickness Normal Stress on Forming Limits under Yld2003 Yield Criterion and M-K Model

Forming Limit Model Evaluation for Anisotropic Sheet Metals under Through-Thickness Normal Stress

Forming Limit Evaluation by Considering Through-Thickness Normal Stress: Theory and Modeling

An extended mesoscaled M-K model for predicting discrete ultimate strains and evaluating the effect of normal stress on forming limits

Construction of 3D sheet forming limit diagrams considering through-thickness normal pressure

The Theoretical Prediction and Numerical Simulation of Sheet Metal Forming Limit

Forming Limit Prediction for Two-Stage Aluminum Alloy Sheet Forming Process Considering the Effect of Normal Stress

Experimental Verification of the Influence of Normal Stress on the Formability of Thin-Walled 5a02 Aluminum Alloy Tubes

Forming limit of hot-rolled high-strength steels considering sheet thickness effect

Sheet metal forming limits under stretch-bending with anisotropic hardening

Investigation on the Material Constitutive Model in Sheet Metal Forming

Research on material flow stress models in common use

Experimental and Numerical Investigation on Sheet Metal Forming Limit Prediction with Thickness Related Criteria

Forming Limit Evaluation with Perturbation Approach Considering Through-Thickness Normal Stress

Forming Limits of a Sheet Metal after Continuous-Bending-Under-Tension Loading

Overview on constitutive modeling for hydroforming with the existence of through-thickness normal stress

Constitutive Model of Micro Sheet Metal Based on the Size Effect

Damage and forming limit analysis in porous ductile sheet metals at room or elevated temperatures

Recent Research Advance of Application of Ductile Fracture Criteria in Sheet Metal Forming Process

A review of research in macroscopic hardening models in numerical simulation of sheet metal forming