Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. The incremental sheet metal forming process, characterized by the step-by-step deformation of sheet metal using a simple die, is classified as a type of plastic deformation technology. This method allows for the formation of complex-shaped parts even without the use of a specialized die. Its notable characteristic lies in its low forming load and high flexibility. To accurately forecast finite element simulation outcomes for the incremental sheet forming of 2024-O aluminum alloy sheets, constructing a precise constitutive model is essential. Typically, the uniform strain range in traditional unidirectional tensile tests does not surpass 0.3, primarily due to the necking phenomenon. This limitation hampers the accurate prediction of the actual large plastic deformation process. To address this issue, a theoretical model describing the stress-strain relationship in metal plastic deformation processes is developed using crystal plasticity theory. The constitutive model for the forming of 2024-O aluminum alloy is then constructed by adjusting the hardening coefficient and hardening index. Utilizing the improved constitutive model, the incremental sheet forming process is simulated using ABAQUS software. Upon comparison with experimental results, it is observed that the Thickness Average Absolute Relative Errors (TAARE) of the adjusted constitutive model at forming angles of 60°, 55°, and 50° are 0.414%, 0.467%, and 0.256%, and The Thickness Root Mean Square Errors (TRMSE) are determined as 0.0121, 0.0116, and 0.0094, respectively. These results indicate that the constitutive model and parameters established in this study can adequately capture the mechanical behavior of 2024-O aluminum alloy during the incremental sheet forming process.

Investigation on the Factors Influencing the Thickness Distribution of Superplastic-Formed Components

Friction changing of direct-reverse superplastic forming to control the thickness distribution

Superplastic forming Ti-6Al-4V titanium alloy cylinder with near uniform thickness distribution

Preforming-die Design and Friction Changing to Control the Thickness Distribution of TC4 Deep Cylinder by Superplastic Forming

Numerical analysis of effect of material and processing parameters on thickness distribution during superplastic die bulging of cavity sensitive materials

Study on the Effects of Forming Parameters on the Plastic Flow of Axisymmetrical Curved Parts in Stamping Process

Effects of preform on thickness distribution of hydroformed Y-shaped tube

An investigation on the friction in a micro sheet metal roll forming processes considering adhesion and ploughing

Analysis of thickness distribution of square-sectional hydroformed parts

Tc4 Deep Cylinder with Uniform Thickness by Friction-Changing Direct-Reverse Superplastic Forming

Research on influence factors of forming force in medium-thick sheet metal extrusion process

Investigation of Shearing Extrusion Forming Process Using Finite Element Method

Numerical Investigations on the Influence of Superimposed Double-Sided Pressure on the Formability of Biaxially Stretched Aa6111-T4 Sheet Metal

On Practical Forming Limits in Superplastic Forming of Aluminum Sheet

Experimental and Numerical Investigation on Sheet Metal Forming Limit Prediction with Thickness Related Criteria

Establishment of a constitutive model for the solid granules medium and its application in sheet metal forming

Formability and Cavitation Behavior of Superplastic Aa5083 Aluminum Alloy under Biaxial Tension

The Effects of Material Property Parameters on the Thickness Distribution of Hydroformed Parts

Study on Thickness Distribution in a Superplastically Formed Bellows Made of Titanium Alloy

Research on incremental forming simulation based on an improved constitutive model

Experimental and numerical study of thermoforming of Al/CFRP hybrid composites