Abstract:The plastic deformation behavior of metal plates has been proved to be affected by loading paths. Plastic flow is a critical component in the mechanical description of plastic deformation, like yield and hardening. In this work, the anisotropic plastic flow of two metal plates (16MnCr5 and S420MC) under non-proportional loading conditions was investigated. Large specimens manufactured along different orientations were pre-tensioned up to various strain levels; subsequently, small uniaxial tensile specimens were cut from the pre-tensioned specimens along different orientations with the interval of 15°, and then loaded to rupture. Meanwhile, the r-value, a measure of anisotropic plastic flow, was recorded. Result shows that for the studied plates which had constant r-value in the monotonic uniaxial tensile tests, a downward evolution of the r-value against plastic strain was observed when the Schmitt angle of two stage loading directions was greater than 90°. As the plastic strain in the subsequent loading stage accumulated, the r-value dropped from a higher level to its original level within a strain range about 6.0%. Based on the transient r-value evolution, a HEXAH-based evolutionary plastic potential model was constructed within the framework of non-associated flow (non-AF) theory. In the model, a local ellipse-shape distortion of the plastic potential surface was defined during plastic deformation process and when the Schmitt angel exceeded 90°, such distortion caused a downward evolution of the r-value in the subsequent deformation. The calibration result indicates that the model could reproduce the transient r-value response relevant to loading path change. The proposed evolutionary plastic potential model can be applied together with different anisotropic hardening models in the non-AF theory to give a detailed description of the plastic deformation behavior and hopefully provide a solution for the accurate simulation of the complex sheet metal forming process.

Rigid–plastic Constitutive Theory for Normal Anisotropic and Planar Isotropic Sheet Metals with Voids

Damage and forming limit analysis in porous ductile sheet metals at room or elevated temperatures

A Constitutive Theory for the Damage of Materials with Dynamic Micro Void Evolution Processes.

Rigid-plastic Meso-Damage Constitutive Theory for Porous Composites Reinforced by Particles

An Elastoplastic Constitutive Description Based on an Ellipsoidal Void Model

LRI Model Lower-Bound Rigid-Plastic Constitutive Model for Isotropic-Hardening Materials with Micro Void Evolution Process.

Deformation and Damage Characteristics of Porous Materials under Different Triaxialities

Damage Constitutive Relationship Involving Void Shape Variation for Pearlitic Steel with Fine Laminar Microstructure

Fracture Prediction in Spin Forming of Anisotropic Metal Sheets

A New Constitutive Model for Anisotropic Sheet Metal with Isotropic Ductile Damage

Constitutive modeling based on non-associated flow rule for anisotropic sheet metals forming

Application of Rigid–plastic Meso-Damage Constitutive Theory to Superplastic Bulge Forming

A constitutive model coupling damage and material anisotropy for wide stress triaxiality

On the Closed-Form Constitutive Relations for Damageable Elasto-Viscoplastic Materials

Sheet Metal Forming Limit Prediction Based on Plastic Deformation Energy

Rigid plastic constitutive theory for porous materials including void evolution and mixed hardening effects

Damage Constitutive Relationship for Pearlitic Steel with Fine Laminar Microstructure

A non-quadratic pressure-sensitive constitutive model under non-associated flow rule with anisotropic hardening: Modeling and validation

Ductile damage model for metal forming simulations including refined description of void nucleation

Phenomenological Uncoupled Ductile Fracture Model Considering Different Void Deformation Modes for Sheet Metal Forming

Experimental and Modeling Investigation on Anisotropic Plastic Flow of Metal Plates under Nonproportional Loading Conditions