Abstract:The CuAlO2 films were prepared on glass and quartz substrates by radio frequency magnetron sputtering with a sintered target composed of Al(OH)3 and Cu2O powders. X-ray diffraction analyses reveal that the as-deposited films are amorphous structure and the as-annealed films are predominated by the CuAlO2 phase along with the Al2O3 phase. Scanning electron microscope (SEM) measurements indicate that grains grow up and surface becomes rougher as a result of increasing temperature. The optical studies show that annealing leads to the reduction of the average transmittance of the films from 60% to 40% for the visible range and the decrease of the fitted refractive index from 2.0 to 1.5. Direct band gaps confirmed by the transmittance and reflectance measurements are estimated to be 3.86 and 3.50 eV for as-deposited and as-annealed films, respectively. As increasing exposure time, water contact angles of the as-deposited films exposed under ultraviolet light source 365 nm or 254 nm decrease from 96.3° and 96.4° to 87.5° and 87.2°, respectively. The variation of contact angle can be attributed to the hydrophobic organic stains on the surface, surface roughness, the formation of Cu2+, and band gap variation of CuAlO2 film. The as-annealed film becomes hydrophilic and its water contact angle is 31.1°. The wetting property of CuAlO2 films is very important for the wide spread application of this material.

Optical Dielectric Behaviors of Copper Zinc Alloy Thin Films

Deposition and Characterization of AZO Thin Films on Flexible Glass Substrates Using DC Magnetron Sputtering Technique

Dielectric properties of the silver–copper alloy films deposited by magnetron sputtering

Dielectric Properties of Aluminum Silver Alloy Thin Films in Optical Frequency Range

Optical and Wetting Properties of CuAlO2 Films Prepared by Radio Frequency Magnetron Sputtering

The Annealing Effect on Optical Properties of Silver Copper Alloy Films

Study on elastic modulus of ultra-thin copper films by in-situ SEM-SPM nanoindentation

Spectroscopic ellipsometry study on the optical dielectric properties of silver platinum alloy thin films

Structural, Electrical, and Optical Properties of ZnInO Alloy Thin Films

Effects of DC Sputtering Power on the Properties of AZO Films Deposited at Room Temperature for CIGS Photovoltaics

Influences of Film Thickness on the Structural, Electrical and Optical Properties of CuAlO2 Thin Films

Room temperature AC electrical, surface micro texture analysis, microwave permittivity and dielectric loss tangent in ZnO films doped by Cu, Al, and CuAl

Optical Properties of Sub-30 Nm-Thick ZnS Films Studied by Spectroscopic Ellipsometry

Structural and Optoelectronic Properties of AZO Thin Films Prepared by RF Magnetron Sputtering at Room Temperature

Amorphous Zr-Cu thin-film alloys with metallic glass behavior

Optical Properties of Zinc-Oxide Films Determined Using Spectroscopic Ellipsometry with Various Dispersion Models

Transparent conductive and near-infrared reflective Cu-based Al-doped ZnO multilayer films grown by magnetron sputtering at room temperature

Optical properties of aluminum silver alloy films deposited by magnetron sputtering

Spectroscopic Ellipsometry Studies on ZnCdO Thin Films with Different Cd Concentrations Grown by Pulsed Laser Deposition

Electrical and optical properties of copper oxide thin films prepared by DC magnetron sputtering

Effect of film thickness on structural and optical properties of ZnS:Cu films prepared by vulcanization