Abstract:The commonly used aluminum–copper alloys in industry are mainly rolled plates and extruded or drawn bars. The aluminum–copper alloys' anisotropy generated in the manufacturing process is unfavorable for subsequent applications. Its underlying mechanism shall be interpreted from a microscopic perspective. This paper conducted the loading simulation on Al–4%Cu alloy crystals at the microscopic scale with molecular dynamics technology. Uniaxial tension and compression loading were carried out along three orientations: X- , Y- , and Z- . It analyzes the micro-mechanisms that affect the performance changes of aluminum–copper alloys through the combination of stress–strain curves and different organizational analysis approaches. As shown by the results, the elastic modulus and yield strength are the highest under tension along the direction. Such is the case for the reasons below: The close-packed plane of atoms ensures large atomic binding forces. In addition, the Stair-rod dislocation forms a Lomer–Cottrell dislocation lock, which has a strengthening effect on the material. The elastic modulus and yield strength are the smallest under tension along the direction, and the periodic arrangement of HCP atom stacking faults serves as the main deformation mechanism. This is because the atomic arrangement on the plane is relatively loose, which tends to cause atomic misalignment. When compressed in different directions, the plastic deformation mechanism is mainly dominated by dislocations and stacking faults. When compressed along the direction, it has a relatively high dislocation density and the maximum yield strength. That should be attributed to the facts below. As the atomic arrangement of the plane itself was not dense originally, compression loading would cause an increasingly tighter arrangement. In such a case, the stress could only be released through dislocations. This research aims to provide a reference for optimizing the processing technology and preparation methods of aluminum–copper alloy materials.

Orientation Dependence of the Deformation Microstructure in Compressed Aluminum

Tensile and Compressive Deformation Behaviors of Commercially Pure Al Processed by Equal-Channel Angular Pressing with Different Dies

Inclination-governed Deformation of Dislocation-Type Grain Boundaries

Orientation dependence of dislocation structure in surface grain of pure aluminium deformed in tension

The Grain Size and Orientation Dependence of Geometrically Necessary Dislocations in Polycrystalline Aluminum During Monotonic Deformation: Relationship to Mechanical Behavior

EFFECTS OF DEFORMATION ON THE MICROSTRUCTURE AND PROPERTIES OF 6082 ALUMINUM ALLOY

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Effect of crystal orientation on the deformation behavior of the magnesium alloy AZ31 during plane strain compression

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

Dislocation Structures In Deformed Metals

Orientation dependence of dislocation structure in surface grain of pure copper deformed in tension

Strain Distribution and Lattice Rotations During In-Situ Tension of Aluminum with a Transmodal Grain Structure

Evolution of deformation mechanisms and their orientation dependence in fine-grained Mg-3Gd during tension

3D Microstructural and Strain Evolution During the Early Stages of Tensile Deformation

Early Compressive Deformation of Closed-Cell Aluminum Foam Based on a Three-Dimensional Realistic Structure

Orientation Dependence of the Deformation Microstructure of Ta-4% W after Cold-Rolling

Molecular Dynamics Simulation Study of Aluminum–Copper Alloys' Anisotropy under Different Loading Conditions and Different Crystal Orientations

In-situ Study of the Effect of Strain Path Change on Dislocation Boundary Evolution in Commercial Purity Aluminum