Abstract:In-plane uniaxial tension of AZ31 magnesium alloy sheet with non-basal texture has been conducted in order to demonstrate the effects of loading direction on the microstructure evolution and mechanical properties at ambient temperature. Loading axes are chosen to be along five directions distributed between rolling direction (RD) and transverse direction (TD), allowing various activities in involved slip and twinning modes to take place. As for twinning modes, electron backscattered diffraction observations confirm that the contribution of \({{\{ 10\overline{1}1\} }}\) compression twinning is minimal to the plastic deformation of all deformed samples. By comparison, \({{\{ 10\overline{1}2\} }}\) extension twinning (ET) not only serves as an important carrier on sustaining and accommodating plastic strain but also contributes to the emergence of TD-component texture with the progression of plastic strain. In terms of slip modes, analysis on Schmid factor demonstrates that the increasing tilted angle between loading direction and RD of sheet is unfavorable to the activation of basal <a> slip, whereas it contributes to the activation of prismatic <a> slip. These observations consequently explain the increasing tendency of 0.2% proof yield stress. Moreover, the activations of basal <a> slip and \({{\{ 10\overline{1}2\} }}\) ET collectively contribute to the concentration of two tilted basal poles toward normal direction. With increasing angle between loading direction and RD, the activations of basal <a> slip and \({{\{ 10\overline{1}2\} }}\) ET are gradually weakened. This leads to a weakening tendency about concentration of two tilted basal poles, a generally increasing tendency about Lankford value (r-value) and a generally decreasing tendency about strain-hardening exponent (n-value).

Effect of crystal orientation on the deformation behavior of the magnesium alloy AZ31 during plane strain compression

Research on deformation mechanism of AZ31 magnesium alloy during uniaxial compression

Microtexture Evolution Via Deformation Twinning and Slip During Compression of Magnesium Alloy AZ31

On the Plasticity and Deformation Mechanisms in Magnesium Crystals

Role of Crystal Orientation in the Dynamic Strength of Magnesium Alloy AZ31B

The effects of orientation control via tension-compression on microstructural evolution and mechanical behavior of AZ31 Mg alloy sheet

Crystal Plasticity Behavior of Single-Crystal Pure Magnesium under Plane-Strain Compression

Influence of Grain Orientation on Twinning During Warm Compression of Wrought Mg–3Al–1Zn

Anisotropic Deformation of Extruded Magnesium Alloy AZ31 under Uniaxial Compression: A Study with Simultaneous in Situ Synchrotron X-Ray Imaging and Diffraction

Effect of deformation conditions on twinning of AZ31 magnesium alloy during compression test

Molecular Dynamics Simulations of Orientation Effects During Tension, Compression, and Bending Deformations of Magnesium Nanocrystals

Dependence of Microstructure Evolution and Mechanical Properties on Loading Direction for AZ31 Magnesium Alloy Sheet with Non-basal Texture During In-Plane Uniaxial Tension

Effect of Sample Orientation on Static Recrystallization of Az31 Magnesium Alloy

Mechanism of Plastic Deformation of As-Extruded AZ31 Mg Alloy during Uniaxial Compression

Orientation factor analysis of deformation mechanisms under special processing techniques in AZ31 magnesium alloys

Deformation Mechanisms of Magnesium Alloys with Rare-Earth and Zinc Additions under Plane Strain Compression

Effect of Loading Direction on Tensile-Compressive Mechanical Behaviors of Mg-5Zn-2Gd-0.2Zr Alloy with Heterogeneous Grains

Effect of texture types on microstructure evolution and mechanical properties of AZ31 magnesium alloy undergoing uniaxial tension deformation at room temperature

Crystal plasticity based modeling of grain boundary sliding in magnesium alloy AZ31B sheet

Study on the deformation behavior of AZ31B-O magnesium alloy with the VPSC model

Orientation dependence of intracrystalline and grain boundary deformation behavior in Mg-2Y using nanoindentation and CPFEM