Abstract:For the aluminium alloys produced by the hot extrusion process, the profile is shaped according to the bearing at the exit of the extrusion die. The tribological process has significant effects on the die service life, profile dimensional tolerances, and profile surface finish. Recently, new technologies have been introduced to the hot extrusion die, such as cemented carbide insert die and surface coating. However, under hot extrusion working conditions, quantitative studies on their friction and wear performances are lacking. In this work, the friction and wear performances of three typical extrusion die materials, traditional hot tool steel (H13), cemented carbide (YG8), and chemical vapour deposition (CVD) coating, were studied. Macro and nano hardness tests, Pin-on-disk friction and wear tests, optical profiler and SEM observations, and experiments and simulations of hot extrusion were conducted. The results show that the coefficients of friction of CVD coatings and H13 hot work tool steel specimens were smaller under the hot extrusion condition than at room temperature. The wear mechanisms of H13, YG8, and CVD coatings at 500 °C are adhesion, abrasive, and fatigue, respectively. Moreover, the tribology results were validated by the extrusion experiments and the finite element analysis of hot extrusion. The conclusion of this manuscript is useful not only for the numerical simulation of the hot extrusion process but also for the surface finishing of the extrusion profile.

The numerical simulation of powder canning hot extrusion of W-40Cu alloy

Numerical simulation of hot hydrostatic extrusion of W-40wt.% Cu

The Influence of Extrusion Ratio on W-40 ％ Cu Alloy Produced by Powder Canning Hot Extrusion

Numerical Simulation of Canned Hot-Extrusion Process of Mo Powder

Numerical Simulation and Experimental Research of the Hydrostatic Extrusion Process of Pure Tungsten

The influence of mechanical milling on microstructure and the properties of W-40Cu composite by hot extrusion

The Theoretical Analysis of Densification Process in Powder Canning Extrusion

SIMULATION OF ALUMINUM FIXTURE PART HOT EXTRUSION PROCESS WITH THE FINITE VOLUME METHOD

Optimization of numerical parameters and microstructure evolution on 2195 Al–Li alloy extrusion process

Numerical Simulation and Process Optimization of Internal Thread Cold Extrusion Process

Optimization of Extrusion Process Parameters of Incoloy028 Alloy Based on Hot Compression Test and Simulation

Numerical Simulation of Extrusion of High Energy Milled Ti/Al Powders

Research on the densification of W–40 wt.%Cu by liquid sintering and hot-hydrostatic extrusion

W-Cu Composites Subjected To Heavy Hot Deformation

Numerical Simulation of 6061 Aluminum Alloys during the Semi-Solid Backward Extrusion

Research on the densification of W-30 wt%Cu composite powder by hot extrusion with steel cup

Experimental and Numerical Study on Friction and Wear Performance of Hot Extrusion Die Materials

Investigation on hot deformation behavior of 2050 Al-Cu-Li alloy

Numerical Simulation for Continuous Extrusion Process of the Flat Multi-Hole Aluminum Tubes

Simulation of Compound Cold Extrusion Al-Zn-Mg-Cu Alumium Alloys

Numerical simulation of the residual stress in the Mg-5Zn-3.5Sn-1Mn-0.5Ca-0.5Cu alloy with different extrusion parameters