Abstract:The original Johnson-Cook model's poor prediction of W90 alloy stress at high strain rate and high and low temperatures restricts research and utilization of this alloy. This study used a Split Hopkinson Pressure Bar (SHPB) device to conduct dynamic compression tests on W90 alloy over a temperature range of [-90°C,700°C] and analyze its mechanical behavior. We examined the material's different plastic phase characteristics at high and low temperatures and conducted microstructure research on impact test specimens. Then, we analyzed the stress-strain data from SHPB experiments and quasi-static compression tests on the classical Johnson-Cook model. The original Johnson-Cook model was calibrated using the stress-strain data from SHPB and quasi-static compression tests, and the modified Johnson-Cook model was established and verified. The results show that: low temperature significantly strengthens the material's stress, while increasing temperature thermal softening reduces stress; increasing strain rate increases the strain generated by the workpiece, causing faster strain hardening and thermal softening effects, resulting in higher and more stable stress; low temperature makes thicker grain boundaries, increasing plastic stress, and increasing strain rate also increases plastic stress, as well as making the material's grain boundaries thicker. The increase of strain rate makes the grain more dense, which will also show up in the increase of stress on the macroscopic level; the modified Johnson-Cook model in this paper has high agreement with experimental data, with a mean value of MAPE of only 1.85 %,which is 90.20 % lower than the traditional model, and the average value of the RMSE is 85.56 % lower than the traditional model. The modified model significantly outperforms the traditional model in predicting stress and better describes stress changes in W90 at different temperatures.

Numerical Simulation and Experimental Research of the Hydrostatic Extrusion Process of Pure Tungsten

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Experimental and Numerical Study on Friction and Wear Performance of Hot Extrusion Die Materials

Numerical Simulation and Process Optimization of Internal Thread Cold Extrusion Process

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Numerical Simulation of Canned Hot-Extrusion Process of Mo Powder

Simulation and Experimental Investigation on Additive Manufacturing of Highly Dense Pure Tungsten by Laser Powder Bed Fusion

Study on dynamic mechanical properties of tungsten copper alloy and application of shaped charge

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Research on hot deformation behavior and numerical simulation of microstructure evolution for Ti–6Al–4V alloy

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Research on hot isostatic pressing sintering behavior of 90W-Ni-Fe-Cu alloy

Comparison of Hydrostatic Extrusion Between Pressure-Load and Displacement-Load Models

Research on hot isostatic pressing sintering behavior of 90W–Ni–Fe–Cu alloy

Effect of Hot Isostatic Pressing Process Parameters on Properties and Fracture Behavior of Tungsten Alloy Powders and Sintered Bars

Numerical simulation of the residual stress in the Mg-5Zn-3.5Sn-1Mn-0.5Ca-0.5Cu alloy with different extrusion parameters

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

Microstructural evolution and hot deformation behavior of W-3Re-5HfC alloy

Research on Holding Pressure and Cooling Process During Hot Forming of Ultra-High Strength Steel 22MnB5

Mechanical properties and JC constitutive modification of tungsten alloys under high strain rates and high/low temperatures

Investigation into the Hot Workability of the As-Extruded WE43 Magnesium Alloy Using Processing Map