Abstract:The methodology and test results of a three-phase three-column transformer with a Dy connection group are presented in this paper. This study covers the dynamics of events that took place in the first period of the transient state caused by the energizing of the transformer under no-load conditions. The origin of inrush currents was analyzed. The influence of factors accompanying the switch-on and the impact of the model parameters on the distribution and maximum values of these currents was studied. In particular, the computational methods of taking into account the influence of residual magnetism in different columns of the transformer core, as well as the impact of the time instant determined in the voltage waveform at which the indicated voltage is supplied to a given transformer winding, were examined. The study was carried out using a nonlinear model constructed on the basis of classical modeling, in which hysteresis is not taken into account. Such a formulated model requires simplification, which is discussed in this paper. The model is described using a system of stiff nonlinear ordinary differential equations. In order to solve the stiff differential state equations set for the transient states of a three-phase transformer in a no-load condition, a Runge–Kutta method, namely the Radau IIA method, with ninth-order quadrature formulas was applied. All calculations were carried out using the authors' own software, written in C#. A ready-made strategy for energizing a three-column three-phase transformer with a suitable pre-magnetization of its columns is given.

Discrimination of Three-Phase Three-Limb Transformer Inrush Current Based on Characteristics of Instantaneous Excitation Inductances

A New Method to Identify Inrush Current Based on HHT

Equivalent Instantaneous Inductance Based Inrush Current Identification for Three-Phase V/V Traction Transformer

The No-Load Performance of 3-Phase Transformer Bank under Direct-Current Bias Based on the 3d Transient Analysis

A New Method to Identify Inrush Current Based on Error Estimation

DISTINGUISH INRUSH CURR ENTS FOR TRANSFORMERS USING FREQUENCY CHARACTERISTIC OF INSTANT ANEOUS EXCITATION INDUCTANCE

Identification of Magnetizing Inrush for Three-phase V/V Traction Transformer

Approach to Calculate Attenuated Magnetizing Inrush Current in Transformer

A Ratio Variation of Equivalent Instantaneous Inductance Based Method to Identify Magnetizing Inrush in Transformers

3-D Nonlinear Transient Eddy Current Calculation of Online Power Transformer under DC Bias

Modeling And Simulation Of Magnetizing Inrush Current Of Large Power Transformers

Identification of Magnetizing Inrush Currents of Power Transformers Based on Features of Flux Locus

A NEW METHOD TO IDENTIFY INRUSH CURRENT BY PHASOR COMPARISON

Three-Phase Transformer Inrush Current Reduction Strategy Based on Prefluxing and Controlled Switching

A novel equivalent instantaneous inductance based algorithm used to distinguish inrush currents for transformers

IDENTIFICATION OF TRANSFORMER MAGNETIC INRUSH CURRENT BASED ON VIRTUAL FLUX AND DIFFERENTIAL CURRENT CHARACTERISTICS

Principle and Influencing Factors of the Transformer Sympathetic Inrush

Unified Algorithm Based on Rotating Phasors for Accurate Detection of Inrush Currents in Three-Phase Transformers

Application of Equivalent Instantaneous Inductance in Nonstaturation Zone to Identify the Sympathetic Inrush in Transformer

Inrush Current Reduction Strategy for a Three-Phase Dy Transformer Based on Pre-Magnetization of the Columns and Controlled Switching

A new algorithm to identify magnetizing inrush of converter transformers in HVDC transmission project