Abstract:It is known that Copper's (Cu) electrical conductivity makes it a desirable material for use in industry. Due to poor properties such as hardness, thermal expansion, and corrosion resistance, its applications are limited. This manuscript solves these problems while maintaining no breakdown in electrical conductivity. In this study, high-strength ceramics (SiC nanoparticles and graphene nanosheets) were used as reinforcements in the manufacture of Cu-based hybrid nanocomposites using powder metallurgy technique. X-ray diffraction analysis (XRD) was used to investigate phase composition and crystal size of the milled powders. Transmission electron microscopy (TEM) and field emission scanning electron microscopy (FESEM), respectively examined the microstructure of the prepared powder powders and sintered nanocomposites. Then, various properties of the sintered samples are measured, including physical, electrical and thermal properties and wear resistance. The obtained XRD technique and TEM images showed decreases in the crystal and particle size of milled samples reaching up to 14.08 and 28.30 nm, respectively for the sample contained 8 vol. % SiC + 0.8 vol. % graphene (SG8). A surprising improvement in the mechanical properties of up to 809.15, 341.84 MPa and 336.56 GPa for microhardness, strength and longitudinal modulus for the sample containing the highest reinforcements, achieving an improvement of up to 122, 61.37 and 41 percent compared to the Cu matrix. Moreover, there was a noticeable improvement in the coefficient of thermal expansion (CTE) and wear rate values of the samples by increasing the percentages of hybrid reinforcements in the examined sintered nanocomposite samples. The Sample SG8 recorded the lowest value, decreasing by about 50.2 and 76.5% compared to the SG1 sample. Finally, adding reinforcements to the Cu matrix had a negative effect on the relative density and electrical conductivity, and the lowest values was 92.94% and8.59 × 10 6 S/m, respectively for the SG sample.

Anisotropic Thermal Expansion Behaviors of Copper Matrix in Β-Eucryptite/copper Composite

Experimental study of thermal expansion behavior on braided structure composite

Effect of the Thermal Expansion Characteristics of Reinforcements on the Electrical Wear Performance of Copper Matrix Composite

Structure and Thermal Expansion of Cu-90 vol. % Graphite Composites

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Effects of Process Parameters on Microstructure and Properties of TiC Reinforced Cu-Matrix Composites

In-plane thermal expansion behavior of dense ceramic matrix composites containing SiBC matrix

Effect of atomic diffusion on interfacial heat transfer and tensile property of copper/aluminum composites

Anisotropic thermal expansion tensor of β -Ga2O3 and its critical role in casting-grown crystal cracking

Fabrication of a Cu/TiNi Composite with High Air-Tightness and Low Thermal Expansion

Fabrication, mechanical and thermal properties of tungsten-copper coated graphite flakes reinforced copper matrix composites

Heterogeneous Internal Strain Evolution in Commercial Purity Titanium Due to Anisotropic Coefficients of Thermal Expansion

Thermal and Electrical Properties of Feni/Cu Composites

Realization of high thermal conductivity and tunable thermal expansion in the ScF3@Cu core-shell composites

In Situ X-ray Diffraction Study on the Orientation-Dependent Thermal Expansion of Cu Nanowires

Thermal expansion coefficient of Cu-Al2O3 nanocomposites by molecular dynamics simulation

A numerical study of the effect of interfacial thermal resistance on thermal conductivity of Cu-B/diamond composites

Microstructure and Thermal Property of W/cu Multilayer Composites

Evaluation of tribo-mechanical measurements and thermal expansion of Cu-based nanocomposites reinforced by high strength hybrid ceramics

Effects of Zr-Cu Alloy Powder on Microstructure and Properties of Cu Matrix Composite with Highly-Aligned Flake Graphite

Thermal Expansion Coefficient of a Pd–Cu Solid Solution