Abstract:The success of microelectromechanical systems (MEMS) as a key technology in the 21st century depends in no small part on the solution of materials issues associated with the design and fabrication of complex MEMS devices. The reliable mechanical properties of these thin films are critical to the safety and functioning of these microdevices and should be accurately determined. In order to accomplish a reliable mechanical design of MEMS, a new microtensile test device using a magnetic-solenoid force actuator was developed to evaluate the mechanical properties of microfabricated polysilicon thin films with dimensions of 100–660 μm length, 20–200 μm width, and 2.4 μm thickness. It was found that the measured average value of Young’s modulus, 164 ±1.2 GPa, falls within the theoretical bounds. The average fracture strength is 1.36 GPa with a standard deviation of 0.14 GPa, and the Weibull modulus is 10.4–11.7, respectively. Statistical analysis of the specimen size effect on the tensile strength predicated the size effect on the length, the surface area and the volume of the specimens due to microstructural and dimensional constraints. The fracture strength increases with the increase of the ratio of surface area to volume. In such cases the size effect can be traced back to the ratio of surface area to volume as the governing parameter. The test data account for the uncertainties in mechanical properties and may be used in the future reliability design of polysilicon MEMS. The testing of 40 specimens to failure results in a recommendation for design that the nominal strain be maintained below 0.0057.

Young's Modulus of Nano Polycrystalline Silicon Film

Young's Modulus Characterization of Nano-Level Silicon Nanomembrane

Young's Modulus Measurement of Nickel Silicide Film on Crystal Silicon by a Surface Profiler

Young’s Modulus of Polycrystalline Titania Microspheres Determined by in Situ Nanoindentation and Finite Element Modeling

Study On The Young'S Modulus Of Silicon Nano-Membrane

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Reduction in Modulus of Suspended Sub-2 nm Single Crystalline Silicon Nanomembranes

Experimental and Theoretical Study of Young Modulus in Micromachined Polysilicon Films

Characterization of the Young's Modulus and Residual Stresses for a Sputtered Silicon Oxynitride Film Using Micro-Structures

A Method of Measuring Young's Modulus and Residual Stress in Typical MEMS Structures Using a Surface Profilometer

Evaluation of Mechanical Properties and Strain Criterion for Realibility Design of Micromachined Polysilicon Thin Films

Scale Dependence of Tensile Strength of Micromachined Polysilicon MEMS Structures Due to Microstructural and Dimensional Constraints

A Simple Extraction Method Of Young'S Modulus For Multilayer Films In Mems Applications

Measurements of Young’s Modulus of Silicon Oxynitride Using Micro-Cantilever Structure

Measurement of Material Properties for Polysilicon Thin Films by an Electrostatic Force Method

Young's Modulus of Silicon Nanoplates at Finite Temperature

Physics-guided machine learning enhanced electrostatic actuated method for in-situ measurement of Young's modulus

Mechanical Properties of Mono-crystalline Silicon Thin Films Measured by Different Methods

Measurement Of Young'S Modulus And Residual Stress Of Micromembranes

Scale Effect on Young's Modulus of a Silicon Nano-Plate

Young's Modulus of Electroplated Ni Thin Film for MEMS Applications