Preparation, microstructure and properties of ABS resin with bimodal distribution of rubber particles

Gongsheng Li,Shulai Lu,JianXun Pang,Yanjun Bai,Liu Zhang,Xuhong Guo

DOI: https://doi.org/10.1016/j.matlet.2011.08.037

IF: 3

2012-01-01

Materials Letters

Abstract:A novel ABS resin with bimodal distribution of rubber particles (BM-ABS) was prepared by bi-seeded emulsion grafting copolymerization (Bi-SEGP) using two different size polybutadiene (PB) particles (320nm and 575nm) as seeds. For property comparisons, a model ABS resin with unimodal distribution of rubber particles (UM-ABS) was prepared by only using 320nm PB particles as seeds. Microscopical morphology of BM-ABS and UM-ABS was observed by transmission electron microscope (TEM). The results showed that BM-ABS possessed higher properties than UM-ABS. Specifically, keeping the same rubber content, BM-ABS had higher toughness than UM-ABS and almost the same rigidity as UM-ABS; keeping the same toughness, BM-ABS had higher rigidity and needed less rubber content than UM-ABS. The synergistic effect of the bigger and the smaller rubber particles was the essential reason why BM-ABS displays improved properties than UM-ABS.