Abstract:Solid oxide fuel cells are not suitable for powering small portable devices, mainly because if built small, they need heat input to keep them running. A new approach to fuel-cell design tackles that problem head on, resulting in the first thermally self-sustaining miniature solid-oxide fuel cell. In this cell, the heat is from the oxidation reaction at the anode. Good power densities are achieved, and as proof of principle, the cell has successfully driven an MP3 player. High energy efficiency and energy density, together with rapid refuelling capability, render fuel cells highly attractive for portable power generation1,2. Accordingly, polymer-electrolyte direct-methanol fuel cells are of increasing interest as possible alternatives to Li ion batteries3. However, such fuel cells face several design challenges and cannot operate with hydrocarbon fuels of higher energy density. Solid-oxide fuel cells (SOFCs) enable direct use of higher hydrocarbons4,5,6, but have not been seriously considered for portable applications because of thermal management difficulties at small scales, slow start-up and poor thermal cyclability. Here we demonstrate a thermally self-sustaining micro-SOFC stack with high power output and rapid start-up by using single chamber operation on propane fuel. The catalytic oxidation reactions supply sufficient thermal energy to maintain the fuel cells at 500–600 °C. A power output of ∼350 mW (at 1.0 V) was obtained from a device with a total cathode area of only 1.42 cm2.

A Direct Flame Solid Oxide Fuel Cell for Potential Combined Heat and Power Generation

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

Direct Flame SOFCs with La[sub 0.75]sr[sub 0.25]cr[sub 0.5]mn[sub 0.5]o[sub 3−δ]∕ni Coimpregnated Yttria-Stabilized Zirconia Anodes Operated on Liquefied Petroleum Gas Flame

A Non-Sealed Solid Oxide Fuel Cell Micro-Stack with Two Gas Channels

A Novel Cell‐Array Design for Single Chamber SOFC Microstack

A Novel Design of Single-Chamber SOFC Micro-Stack Operated in Methane–oxygen Mixture

Experimental Characterization of a Direct Methane Flame Solid Oxide Fuel Cell Power Generation Unit

Anode-Supported Micro-SOFC Stacks Operated under Single-Chamber Conditions

Direct Operation of Solid Oxide Fuel Cells on Low-Concentration Oxygen-Bearing Coal-Bed Methane with High Stability

Micro-tubular Solid Oxide Fuel Cell Stack Operated with Catalytically Enhanced Porous Media Fuel-Rich Combustor

Study of a Single‐Chamber Solid Oxide Fuel Cell Microstack with V‐Shaped Congener‐Electrode‐Facing Configuration

Propane-fuelled microtubular solid oxide fuel cell stack electrically connected by an anodic rectangular window

A Thermally Self-Sustained Micro Solid-Oxide Fuel-Cell Stack with High Power Density

A Robust Flat-Chip Solid Oxide Fuel Cell Coupled with Catalytic Partial Oxidation of Methane

Biogas-Fueled Flame Fuel Cell for Micro-Combined Heat and Power System

Performance of Anode-Supported Single-Chamber Solid Oxide Fuel Cells

Clean and Stable Conversion of Oxygen-Bearing Low-Concentration Coal Mine Gas by Solid Oxide Fuel Cells with an Additional Reforming Layer

Co-Generation of Electricity and Chemicals via Solid Oxide Fuel Cells Using Li-Doped LSGM and LSF Composite Anodes

Electrical and Stability Performance of Anode-Supported Solid Oxide Fuel Cells with Strontium- and Magnesium-Doped Lanthanum Gallate Thin Electrolyte

Performance Characteristics of a Micro-tubular Solid Oxide Fuel Cell Operated with a Fuel-rich Methane Flame