Abstract:The exergy-based multi-disciplinary optimization (MDO) method has been applied to conceptual design of a scramjet engine by analyzing the available energy in each subsystem within a highly integrated and high efficiency required vehicle. Regarding the conceptual design of a scramjet, the stream thrust method has been adopted to calculate each subsystem’s in/out area, i.e., inlet, isolator, combustor and nozzle. Next, a newly developed evaluation program was utilized to evaluate the performance of the vehicle’s internal flow. With the calculated state parameters obtained from the evaluation program results, the exergy analysis was then performed. Subsequently, genetic algorithm and non-dominated sorting genetic algorithm were used to optimize the design variables. The maximum exergy efficiency was measured and the specific impulse (Isp) optimization was conducted separately, and a multi-objective optimization containing both was also investigated. The results demonstrated that the optimization objective with exergy efficiency was suitable for long-endurance vehicles and high-efficiency fuel utilization, the maximum Isp was suitable for high acceleration and high thrust, and the Pareto front could address both needs. It was also found that the cycle static temperature ratio and static pressure ratio of the nozzle should be specifically set at an optimized value to obtain the maximum exergy efficiency and Isp.

Off-Design Condition Cooling Capacity Analysis of Recooling Cycle for A Scramjet

Thermodynamic optimization for a scramjet with Re-cooled Cycle

Heat Transfer Characteristic Modelling and the Effect of Operating Conditions on Re-Cooled Cycle for A Scramjet

Effect of Cooling Channel Geometry on Re-Cooled Cycle Performance for Hydrogen Fueled Scramjet

Comparison during a scramjet regenerative cooling and recooling cycle

Performance Cycle Analysis of an Open Cooling Cycle for a Scramjet

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

Parametric Performance Analysis of Multiple Re-Cooled Cycle for Hydrogen Fueled Scramjet

Irreversible Cycle Analysis of a Re-Cooled Cycle for a Scramjet

Flow and heat transfer characteristics in fuel cooling channels of a recooling cycle

Thermodynamic Analysis and Parametric Study of a Closed Brayton Cycle Thermal Management System for Scramjet

Experimental Study on the Performance of Recooling Cycle of Hydrocarbon Fueled Scramjet Engine

Active Cooling Design on Heat Transfer Enhancement for Scramjet Engines Using Optimization Methods

Comparison Analysis Between Expander Cycle and Recooling Cycle for A Scramjet

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Performance Limit Analysis of Recooled Cycle for Regenerative Cooling Systems

Efficient utilization of heat sink of hydrocarbon fuel for regeneratively cooled scramjet

Parametric numerical analysis of regenerative cooling in hydrogen fueled scramjet engines

Performance Analysis and Optimization of a Novel S-CO2 Closed-Brayton-cycle-based Thermal Management System for Scramjets

Power Generation and Heat Sink Improvement Characteristics of Recooling Cycle for Thermal Cracked Hydrocarbon Fueled Scramjet

Study on Combined Thermal Protection Scheme Integrating Supercritical CO2 Regenerative Cooling and Fuel Film Cooling Used for Scramjet Engines