Abstract:A control-oriented unsteady 1-D model for regeneratively-cooled scramjet engine which is composed of flow-combustion module, regenerative cooling module, is presented in this paper. It can reflect unsteady process in real-world where flow-combustion module couples with regenerative cooling module at each time step. The coupled 1-D model is quantitatively validated under steady and unsteady conditions. By the analyses of steady characteristics using this coupled 1-D model, it can be concluded that the allowable maximum first stage fuel equivalence ratio of regeneratively-cooled scramjet engine is lower and thrust is larger than no-cooled scramjet engine for the same equivalence ratio under the same flight Mach number. The difference of overtemperature boundary between regeneratively-cooled and no-cooled scramjet engine is also pointed. Moreover, regenerative cooling process results in moving toward less of fuel equivalence ratio of combustion mode transition. Unsteady characteristics analyses are investigated subsequently. Results indicate that there exists thermal inertia after kerosene flowing in cooling channels so that the flow rate of kerosene of entering into combustor cannot reflect kerosene changing signal in time. It leads to that thrust response time of regeneratively-cooled scramjet engine is longer than that of no-cooled scramjet engine. Some special attentions should be paid that combustion mode transition can be induced and affected by regenerative cooling process in some conditions. As a whole, the low computation cost makes this coupled 1-D model suitable for control system design and overall performance evaluation for regeneratively-cooled scramjet engine.

Regeneratively cooled scramjet heat transfer calculation and comparison with experimental data

Parametric numerical analysis of regenerative cooling in hydrogen fueled scramjet engines

Progress of Coupled Heat Transfer Mechanisms of Regenerative Cooling System in a Scramjet

Numerical investigation on regeneration-transpiration combined cooling of cavity structure in scramjet engine

Experimental study on measurement and calculation of heat flux in supersonic combustor of scramjet

Comparison during a scramjet regenerative cooling and recooling cycle

A decoupled procedure for convection-radiation simulation in scramjets

Efficient utilization of heat sink of hydrocarbon fuel for regeneratively cooled scramjet

Insight into jet-regeneration composite cooling technology employed in scramjet: Significance of relative positions of two jet holes

Numerical Analysis of Convective Heat Transfer Characteristics of Supercritical Hydrocarbon Fuel in Cooling Panel with Local Flow Blockage Structure

Performance Evaluation of Regenerative Cooling/film Cooling for Hydrocarbon Fueled Scramjet Engine

Heat Transfer Characteristic Modelling and the Effect of Operating Conditions on Re-Cooled Cycle for A Scramjet

A review of regenerative cooling technologies for scramjets

Study of Heat Transfer of Composite Lattice Structure for Active Cooling Used in the Scramjet Combustor

Quasi-One-Dimensional Model of Hydrocarbon-Fueled Scramjet Combustor Coupled with Regenerative Cooling

Numerical Investigation of the Thermal-Mechanical Behaviors in the Regenerative Cooling Channel Considering Thermal Pyrolysis

Hydrogen-fueled Scramjet Cooling System Investigation Using Combustor and Regenerative Cooling Coupled Model

Flow Field and Heat Transfer Analysis of Local Structure for Regenerative Cooling Panel

Numerical heat transfer analysis of transcritical hydrocarbon fuel flow in a tube partially filled with porous media

Quasi-One-Dimensional Model of Scramjet Combustor Coupled with Regenerative Cooling

Control-oriented Unsteady One-Dimensional Model for a Hydrocarbon Regeneratively-Cooled Scramjet Engine