Abstract:Regenerative cooling is one of the most promising schemes for providing thermal protection for scramjets. Under multiple cooling channels, flow maldistribution easily leads to overheating and structural failures. Considering the complicated thermal environment in scramjet combustors, this study focuses on the relationship between flow maldistribution and heat transfer non-uniformity to improve the thermal performance. After validating the flow and heat transfer distributions, three types of heat flux boundary conditions and seven geometric configurations are numerically investigated with n-decane as the coolant. The conventional Z-type parallel channels are modeled with severe flow maldistribution, with the highest mass flow rate being four times more than the lowest. Moreover, the non-uniform heat boundary condition causes the maximum temperature with (486.71 K) to significantly vary. To realize a uniform flow distribution, a baffle structure is introduced into the inlet manifold, where high-pressure zones exist near the ribs and flow redistribution occurs. The modified geometry model comprises five additional channels, resulting in a more uniform flow distribution, higher pressure drops, and smaller variation of the maximum temperature under three types of heat loads. Furthermore, the influence of location and quantity of additional channels is analyzed with five additional geometry models. The dominant effect of the geometric structure is revealed, and the influence of heat flux condition strengthens when the flow maldistribution intensifies. The pressure drop in the inlet header increases with decreasing flow area. Additionally, the matching degree of the real and reference flow distributions (MDRR) is defined, which exhibits a better correlation with the thermal performance than flow uniformity. The maximum temperature increases with the MDRR. Moreover, the mass flow rate distribution is not the sole determining factor. The flow field in the inlet manifold also plays a role, contributing to the complexity of the relationship.

Numerical investigation on regeneration-transpiration combined cooling of cavity structure in scramjet engine

Progress of Coupled Heat Transfer Mechanisms of Regenerative Cooling System in a Scramjet

SHOCK INDUCED SEPARATING FLOWS IN SCRAMJET INTAKES

A review of regenerative cooling technologies for scramjets

Insight into jet-regeneration composite cooling technology employed in scramjet: Significance of relative positions of two jet holes

Transpiration Cooling of High Pressure Turbine Vane with Optimized Porosity Distribution

Numerical Investigation of the Thermal-Mechanical Behaviors in the Regenerative Cooling Channel Considering Thermal Pyrolysis

Regeneratively cooled scramjet heat transfer calculation and comparison with experimental data

Heat Transfer Enhancement of Regenerative Cooling Channel with Pyramid Lattice Sandwich Structures

Flow maldistribution and heat transfer non-uniformity with an inlet baffle structure in regenerative cooling channels

Numerical investigation of mixing performance in supersonic cold flow over dual-cavity in scramjet

Numerical Simulation Of Transpiration Cooling For Sintered Metal Porous Strut Of The Scramjet Combustion Chamber

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Influences of interconnection structure on the flow and heat transfer behaviors of the hydrocarbon fuel in parallel SCRamjet regenerative cooling channels

Investigation of multi-scale flow structures and combustion characteristics in a cavity-enhanced circular scramjet

Numerical Investigation of Convective Heat Transfer of Supercritical Hydrocarbon Fuel in a Tube Filled With Porous Media

On the residence enhancement mechanism of the cavity-based dual-mode scramjet combustor through the Eulerian and Lagrangian analysis

Numerical study of supercritical-pressure fluid flows and heat transfer of methane in ribbed cooling tubes

A decoupled procedure for convection-radiation simulation in scramjets

Numerical Investigation on Cavity Structure of Solid-Fuel Scramjet Combustor

Thermal-mechanical Coupling Analysis of the Ribbed Channels in Regenerative Cooling