Abstract:A control-oriented unsteady 1-D model for regeneratively-cooled scramjet engine which is composed of flow-combustion module, regenerative cooling module, is presented in this paper. It can reflect unsteady process in real-world where flow-combustion module couples with regenerative cooling module at each time step. The coupled 1-D model is quantitatively validated under steady and unsteady conditions. By the analyses of steady characteristics using this coupled 1-D model, it can be concluded that the allowable maximum first stage fuel equivalence ratio of regeneratively-cooled scramjet engine is lower and thrust is larger than no-cooled scramjet engine for the same equivalence ratio under the same flight Mach number. The difference of overtemperature boundary between regeneratively-cooled and no-cooled scramjet engine is also pointed. Moreover, regenerative cooling process results in moving toward less of fuel equivalence ratio of combustion mode transition. Unsteady characteristics analyses are investigated subsequently. Results indicate that there exists thermal inertia after kerosene flowing in cooling channels so that the flow rate of kerosene of entering into combustor cannot reflect kerosene changing signal in time. It leads to that thrust response time of regeneratively-cooled scramjet engine is longer than that of no-cooled scramjet engine. Some special attentions should be paid that combustion mode transition can be induced and affected by regenerative cooling process in some conditions. As a whole, the low computation cost makes this coupled 1-D model suitable for control system design and overall performance evaluation for regeneratively-cooled scramjet engine.

Comparison during a scramjet regenerative cooling and recooling cycle

Heat Transfer Characteristic Modelling and the Effect of Operating Conditions on Re-Cooled Cycle for A Scramjet

Thermodynamic optimization for a scramjet with Re-cooled Cycle

Off-Design Condition Cooling Capacity Analysis of Recooling Cycle for A Scramjet

Flow and heat transfer characteristics in fuel cooling channels of a recooling cycle

Effect of Cooling Channel Geometry on Re-Cooled Cycle Performance for Hydrogen Fueled Scramjet

Irreversible Cycle Analysis of a Re-Cooled Cycle for a Scramjet

Performance Cycle Analysis of an Open Cooling Cycle for a Scramjet

Quasi-One-Dimensional Model of Scramjet Combustor Coupled with Regenerative Cooling

Progress of Coupled Heat Transfer Mechanisms of Regenerative Cooling System in a Scramjet

Regeneratively cooled scramjet heat transfer calculation and comparison with experimental data

Comparison Analysis Between Expander Cycle and Recooling Cycle for A Scramjet

Efficient utilization of heat sink of hydrocarbon fuel for regeneratively cooled scramjet

Parametric Performance Analysis of Multiple Re-Cooled Cycle for Hydrogen Fueled Scramjet

Performance Evaluation of Regenerative Cooling/film Cooling for Hydrocarbon Fueled Scramjet Engine

Quasi-One-Dimensional Model of Hydrocarbon-Fueled Scramjet Combustor Coupled with Regenerative Cooling

A review of regenerative cooling technologies for scramjets

Numerical investigation on regeneration-transpiration combined cooling of cavity structure in scramjet engine

Parametric numerical analysis of regenerative cooling in hydrogen fueled scramjet engines

Study on Combined Thermal Protection Scheme Integrating Supercritical CO2 Regenerative Cooling and Fuel Film Cooling Used for Scramjet Engines

Control-oriented Unsteady One-Dimensional Model for a Hydrocarbon Regeneratively-Cooled Scramjet Engine