Abstract:A control-oriented unsteady 1-D model for regeneratively-cooled scramjet engine which is composed of flow-combustion module, regenerative cooling module, is presented in this paper. It can reflect unsteady process in real-world where flow-combustion module couples with regenerative cooling module at each time step. The coupled 1-D model is quantitatively validated under steady and unsteady conditions. By the analyses of steady characteristics using this coupled 1-D model, it can be concluded that the allowable maximum first stage fuel equivalence ratio of regeneratively-cooled scramjet engine is lower and thrust is larger than no-cooled scramjet engine for the same equivalence ratio under the same flight Mach number. The difference of overtemperature boundary between regeneratively-cooled and no-cooled scramjet engine is also pointed. Moreover, regenerative cooling process results in moving toward less of fuel equivalence ratio of combustion mode transition. Unsteady characteristics analyses are investigated subsequently. Results indicate that there exists thermal inertia after kerosene flowing in cooling channels so that the flow rate of kerosene of entering into combustor cannot reflect kerosene changing signal in time. It leads to that thrust response time of regeneratively-cooled scramjet engine is longer than that of no-cooled scramjet engine. Some special attentions should be paid that combustion mode transition can be induced and affected by regenerative cooling process in some conditions. As a whole, the low computation cost makes this coupled 1-D model suitable for control system design and overall performance evaluation for regeneratively-cooled scramjet engine.

Hydrogen-fueled Scramjet Cooling System Investigation Using Combustor and Regenerative Cooling Coupled Model

Quasi-One-Dimensional Model of Hydrocarbon-Fueled Scramjet Combustor Coupled with Regenerative Cooling

Quasi-One-Dimensional Model of Scramjet Combustor Coupled with Regenerative Cooling

Parametric numerical analysis of regenerative cooling in hydrogen fueled scramjet engines

Control-oriented Unsteady One-Dimensional Model for a Hydrocarbon Regeneratively-Cooled Scramjet Engine

Progress of Coupled Heat Transfer Mechanisms of Regenerative Cooling System in a Scramjet

Efficient utilization of heat sink of hydrocarbon fuel for regeneratively cooled scramjet

Effect of Cooling Channel Geometry on Re-Cooled Cycle Performance for Hydrogen Fueled Scramjet

Quasi-one-dimensional Model of Supersonic a Combustor with Various Fuels

Inhomogeneous Behavior of Supercritical Hydrocarbon Fuel Flow in a Regenerative Cooling Channel for a Scramjet Engine

Study on numerical simulation of the dual-mode scramjet combustor

Performance Evaluation of Regenerative Cooling/film Cooling for Hydrocarbon Fueled Scramjet Engine

Control-oriented Modeling and Real-Time Simulation Method for a Dual-Mode Scramjet Combustor

Heat Transfer Characteristic Modelling and the Effect of Operating Conditions on Re-Cooled Cycle for A Scramjet

Study on Combined Thermal Protection Scheme Integrating Supercritical CO2 Regenerative Cooling and Fuel Film Cooling Used for Scramjet Engines

A decoupled procedure for convection-radiation simulation in scramjets

Nonequilibrium Heating/Cooling Effects in a Mach Number 10 Hydrogen-Fueled Scramjet

Parametric Study on the Hydrocarbon Fuel Flow Rate Distribution and Cooling Effect in Non-Uniformly Heated Parallel Cooling Channels

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Performance analysis of a thermal management system based on hydrocarbon-fuel regenerative cooling technology for scramjets

Numerical investigation of combustion field of hypervelocity scramjet engine