Abstract:This investigation delves into the residual stresses that arise during the deep drawing process of laser-welded blanks (LWBs) using a combination of experimental and numerical methods. While LWBs are preferred for their low distortion and high-quality welds, they are subjected to detrimental residual stresses during forming operations that can adversely affect their service life. The primary objective of this study is to evaluate the influence of five essential process parameters, namely welding power, welding speed, blank holder forces (BHF), friction coefficient, and material properties, on the residual stresses that are generated during the welding and forming of LWBs. Moreover, the study seeks to optimize these process parameters for the deep drawing process utilized in this investigation using response surface methodology (RSM). The hole-drilling method, a commonly used experimental technique for measuring residual stresses, was employed in this study to measure the residual stresses in different zones of laser-welded blanks (LWBs). The measurements were performed using a strain gauge rosette and were repeated three times to ensure accuracy. In addition, the Simufact package and Abaqus Unified FEA software are utilized to simulate the laser beam welding and forming processes, respectively. The close alignment between experimental and simulated outcomes suggests that the model is suitable for numerical simulation of the LWB deep drawing process (less than 10%). By conducting an analysis of variance, the main factors that influence the residual stresses in the welding and forming processes are identified. The findings suggest that welding power–welding speed (30.89%) and BHF (21.65%) have the most significant impact on residual stresses. Furthermore, selecting BHF = 50140.67N, friction coefficient = 0.2, welding speed = 7.4 mm/s, and welding power = 144.79W can enhance the confidence coefficient of the welding zone design.

Drawing Process of Tailor Welded Blank Car Center Pillar Based on FEA

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Parameters Optimization of Tailor Welded Blank Forming Process

Optimum Design of Progressive Die Drawing Sequence Based on Finite Element Analysis

Study on Formability of Tailor Welded Blanks Based on Numerical Simulation

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

The Forming Limits Prediction Model for Tailor Welded Blank with Straight Seam

Insight into the Key Process Parameters on Residual Stress Distribution in Deep Drawing of Laser-Welded Blanks: Response Surface Modeling

Numerical Simulation and Process Improvement of a Typical Car Thread Plate

Research on the non-uniform deformation of deep drawing tailor-welded square boxes

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Finite element simulation and experimental study of non-blank holder forward and backward composite deep drawing earing test

Stamping Process Optimization for the Rear Part of Door Inner Pane(lContinued 1)

A Systematic Study on the Effects of Process Parameters on Spinning of Thin-Walled Curved Surface Parts With 2195 Al-Li Alloy Tailor Welded Blanks Produced by FSW

Finite Element Simulation For Blanking Process Of Sheet Metal

Analysis of Drawing Process for Cigarette Lighter Shell Based on Dynaform

Finite element modeling and analysis of the self-piercing riveting forming process with the ball-shaped die

Die Design for Cylinder-shaped and Thin-walled Part

Optimization of Process Parameters in Deep Drawing Process Based on Orthogonal Experiment Method

An improved fused deposition modeling process for forming large-size thin-walled parts

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet