Abstract:Abstract In the present investigation, the closed-cell Al foam was fabricated by friction stir processing (FSP) combined with heat treatment. The influences of process parameters on microstructures of closed-cell Al foam precursor were investigated by optical metallographic microscope and scanning electronic microscope (OM/SEM). Fluent CFD software was developed to simulate the temperature field and flow field in friction stir processing. The cupping test values were compared for base metal and different weld passes. The results show that the welding speeds have little effect on the mixing of powder in the stir zone because of the relatively small welding heat input. However, the pore size and pore morphology are highly sensitive to change in the rotating speeds. When the welding speed is 50mm/min and the rotating speed is 2000rpm, the powder ring is continuous and uniform due to sufficient plastic deformation and flow. When the foaming time is 110s, the expansion rate of the whole foam increases rapidly, and the diameter of the pore is uniform. Numerical simulation shows that the welding heat mainly comes from the shoulder of the stirring head and the welding temperature peak appears near the stirring pin. The maximum flow velocity appears at the outer edge of the shaft shoulder in which the aluminum matrix is softened preferentially. When the rotating speed increases to 2000r/min, the velocity of the outermost edge of the shaft shoulder increases by 59.96%, and the maximum temperature at the stirring pin reaches 491°C which is consistent with the experimental results. The formability of the joint interface is improved. The cupping test values increase with the increase of deformation temperature. Especially the cupping test value of foamed preform is close to that of base metal at 450°C.

Study on Porosity of Stiring-Formed by Gelcasting Foams

Study on porosity of porous ceramics stirring-formed by gelcasting foams

Study of Affecting Factors on Porosity in Gel-Casting Foam

Pore-scale computational analyses of non-Darcy flow through highly porous structures with various degrees of geometrical complexity

Porous Ceramic from Particle-Stabilised Foams Via Gelcasting

Investigation on the influence of particle size and porosity on solid phase fluidization and heat transfer in carbon fibre porous media

Quantitative characterization and control mechanism of pore structure in geopolymer foams with addition of various surfactants

The Effect Of Processing Parameters On The Rheological Property Of Foam Slurry Of Gangue

Pore Structure Control of Si3n4 Ceramics Based on Particle-Stabilized Foams

Fabrication of Porous Mullite Ceramics with High Porosity Using Foam-Gelcasting

Study on Relation of Foaming Parameters and Cavity

Numerical investigation of influences of porous density and strain-rate effect on dynamical responses of aluminum foam

THE STUDY OF THE SLURRY PROPERTIES OF Si_3N_4 FOAM CERAMICS

The Influences of Process Parameters on the Preparation of Closed-cell Aluminum foam by Friction Stir Processing

Studies on formation of shrinkage cavity and porosity of steel castings by taking filling process into account

Preparation and Properties of Micro porous Si3N4 Ceramics by Gelcasting

Characterization of Stone Powder Sludge Foams and Their Application to Wastewater Treatment: Role of Pore Connectivity

Numerical Study on Fluid Flow Behavior and Heat Transfer Performance of Porous Media Manufactured by a Space Holder Method

Study on particle-stabilized Si3N4 ceramic foams

Effects of Foaming Agent on Microstructure and Properties of Porous Mullite Ceramics

Numerical analysis on the effect of graded porosity in closed-cell metal foams/PCM composites