Abstract:The brittleness of Si3N4 ceramics has always limited its wide application. In this paper, Si3N4 ceramics were prepared based on foam. Combining the unique honeycomb structure of the ceramic foams and the self-toughening mechanism of Si3N4, the strengthening and toughening of Si3N4 ceramics can be further achieved by adjusting the microstructure of Si3N4 ceramic foams. The powder particles are self-assembled by particle-stabilized foaming to form a foam body with a honeycomb structure. It was pretreated at different temperatures (1450-1750 degrees C). The microstructure evolution of foamed ceramics at different pretreatment temperatures and the conversion rate of alpha-Si3N4 to beta-Si3N4 at different pretreatment temperatures were explored. Then the foamed ceramics with different microstructures are hot-press sintered to prepare Si3N4 dense ceramics. The effects of different microstructures of foamed ceramics on the strength and toughness of Si3N4 ceramics were analyzed. The experimental results show that the relative density of Si3N4 ceramics prepared at a particle pretreatment temperature of 1500 degrees C is 97.8%, and its flexural strength and fracture toughness are relatively the highest, which are 1089 +/- 60 MPa and 12.9 +/- 1.3 MPa m(1/2), respectively. Compared with the traditional powder hot-pressing sintering, the improvement is 21% and 33%, respectively. It is shown that this method of preparing Si3N4 ceramics based on foam has the potential to strengthen and toughen Si3N4 ceramics.

Study on particle-stabilized Si3N4 ceramic foams

Pore Structure Control of Si3n4 Ceramics Based on Particle-Stabilized Foams

Preparation of Si3N4 Foam Ceramics Using Short-Chain Amphiphile

Factors affecting the microstructure of a fine ceramic foam

Microstructure of Ceramic Foams

A Novel Method of Strong and Tough Si3N4 Ceramic from the Particle‐stabilized Foam

Ultralight Silicon Nitride Ceramic Foams from Foams Stabilized by Partially Hydrophobic Particles

Preparation of Si 3N 4 foam ceramics with nest-like cell structure by particle-stabilized foams

Effect of carboxymethyl cellulose addition on the properties of Si3N4 ceramic foams

Ultralight and Mechanically Robust SiC Foams with Interconnected Cellular Architecture

Mullite Ceramic Foams with Tunable Pores from Dual-Phase Sol Nanoparticle-Stabilized Foams

Porous Ceramic from Particle-Stabilised Foams Via Gelcasting

In Situ Synthesis of Three-Dimensional Nanofiber-Knitted Ceramic Foams Via Reactive Sintering Silicon Foams

Synthesis of a foam ceramic based on ceramic tile polishing waste using SiC as foaming agent

Ultralight Alumina Ceramic Foams with Single-Grain Wall Using Sodium Dodecyl Sulfate As Long-Chain Surfactant

Ceramic foams with highly open channel structure from direct foaming method in combination with hollow spheres as pore-former.

Effects of Foaming Agent on Microstructure and Properties of Porous Mullite Ceramics

THE STUDY OF THE SLURRY PROPERTIES OF Si_3N_4 FOAM CERAMICS

Silica Foams With Ultra-Large Specific Surface Area Structured By Hollow Mesoporous Silica Spheres

Preparation of ceramic foams from ceramic tile polishing waste and fly ash without added foaming agent