Abstract:The amplitude and phase imbalances of the in-phase (I) and quadrature (Q) branches inherent in the direct conversion receiver structure cause the generation of image frequency interference signals. In this paper, a frequency-domain I/Q imbalance calibration algorithm is proposed for wideband direct conversion receivers. The I/Q imbalance model is rebuilt by applying the infinitesimal method and FFT algorithm. The mathematical expressions for the exact computation of the I/Q imbalance parameters are derived based on the frequency-domain statistical properties of the baseband signal. The two phase parameters, frequency-dependent I/Q imbalance (FD-IQI) and frequency-independent I/Q imbalance (FI-IQI), are separated according to the parity properties of the imbalance parameter. To avoid the interference from the transmitter, the receiver impairment estimation is performed using a frequency offset (FO) DC training signal, and a low-cost real-valued compensation (RVC) filter is introduced to correct the impairments of the received signal. The performances of the proposed calibration model are evaluated through simulations and experiments. The simulation results show that the image rejection ratio (IRR) is improved to 80-120 dBc and can also exceed 40 dBc at high noise levels. The experimental results based on the CX9261A evaluation board show that the average IRR of the multi-tone signal is increased by 24.99 dB, and the IRR of the wideband signal is increased by 19.08 dB.

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

An Effective DC Offset Calibration Method Combined with Analog and Digital Circuits for Direct Conversion Receivers

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 14-Bit 500-Ms/S Sha-Less Pipelined Adc In 65nm Cmos Technology For Wireless Receiver

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

CMOS High-ⅡP2 Mixer for Direct Conversion Receivers

A 0.1–5.0 GHz Flexible SDR Receiver with Digitally Assisted Calibration in 65 Nm CMOS

CMOS RF mixer with digitally enhanced IIP2

Adaptive Digital Calibration Techniques for Narrow Band Low-If Receivers with On-Chip Pll

Digital Calibration Of Gain And Linearity In A Cmos Rf Mixer

A Low Power Direct Conversion Receiver RF Front-End with High In-Band IIP2/IIP3 and Low 1/f Noise

A Hybrid Approach To I/Q Imbalance Self-Calibration In Reconfigurable Low-If Receivers

A Novel BiST and Calibration Technique for CMOS Down-Converters

A Dual-Mode Analog Baseband Utilizing Digital-Assisted Calibration for WCDMA/GSM Receivers

Design of a High-Linearity RF Front-End with IP2 Calibration for SAW-less WCDMA Receivers.

A Hybrid Scheme for TX I/Q Imbalance Self-Calibration in a Direct-Conversion Transceiver

Automatic IQ Phase Calibration Design in a 2.4ghz Direct Conversion Receiver