Abstract:A novel background calibration technique for Time-Interleaved Analog-to-Digital Converters (TI-ADCs) is presented in this paper. This technique is applicable to equalized digital communication receivers. As shown by Tsai et al. [1] and Luna et al. [2], in a digital receiver it is possible to treat the TI-ADC errors as part of the communication channel and take advantage of the adaptive equalizer to compensate them. Therefore calibration becomes an integral part of the channel equalization. No special purpose analog or digital calibration blocks or algorithms are required. However, there is a large class of receivers where the equalization technique cannot be directly applied because other signal processing blocks are located between the TI-ADC and the equalizer. The technique presented here generalizes earlier works to this class of receivers. The error backpropagation algorithm, traditionally used in machine learning, is applied to the error computed at the receiver slicer and used to adapt an auxiliary equalizer adjacent to the TI-ADC, called the Compensation Equalizer (CE). Simulations using a dual polarization optical coherent receiver model demonstrate accurate and robust mismatch compensation across different application scenarios. Several Quadrature Amplitude Modulation (QAM) schemes are tested in simulations and experimentally. Measurements on an emulation platform which includes an 8 bit, 4 GS/s TI-ADC prototype chip fabricated in 130nm CMOS technology, show an almost ideal mitigation of the impact of the mismatches on the receiver performance when 64-QAM and 256-QAM schemes are tested. An absolute improvement in the TI-ADC performance of $\sim$15 dB in both SNDR and SFDR is measured.

A Novel BiST and Calibration Technique for CMOS Down-Converters

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

Digital Calibration Of Gain And Linearity In A Cmos Rf Mixer

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

An Effective DC Offset Calibration Method Combined with Analog and Digital Circuits for Direct Conversion Receivers

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A Maximum-Likelihood-Estimation-Based Digital Background Calibration Technique for Interstage Gain Error in Pipelined ADCs

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

CMOS RF mixer with digitally enhanced IIP2

A Digital Calibration Technique for an Ultra High-Speed Wide-Bandwidth Folding and Interpolating Analog-to-digital Converter in 0.18μm CMOS Technology

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

Adaptive calibration of IIP2 in direct down-conversion mixers with modified LMS algorithm

A Calibration Technique Based on Frequency-Domain Characteristics for Pipelined ADCs

A Novel Approach to Calibrate Open-Loop Amplifier Nonlinearities Through Piecewise Linear Interpolation

Digital Calibration Method for High Resolution in Analog/RF Designs

An Implementation of a CMOS Down-Conversion Mixer for GSM1900 Receiver

Design and Experimental Verification of a Novel Error-Backpropagation-Based Background Calibration for Time Interleaved ADC in Digital Communication Receivers

Calibration technique tracking temperature for current-steering digital-to-analog converters

Exploiting Process Variation and Noise in Comparators to Calibrate Interstage Gain Nonlinearity in Pipelined Adcs

A Hybrid Scheme for TX I/Q Imbalance Self-Calibration in a Direct-Conversion Transceiver