Abstract:In this study, the hot deformation behavior of a Ti–42Al-8.5 V alloy with a martensitic staring microstructure was investigated for the first time. For comparison, the same alloy but with a Widmannstatten lamellar structure was also prepared and deformed at identical conditions. It was shown that the martensite exhibited a much lower stress exponent and pronounced flow softening, and the hot-workability was drastically improved. With the aid of the rapid decomposition of the martensite, an excellent fine-grained structure with negligible micro-texture was obtained in a wide temperature-strain rate regime, which was mostly surrounded by high-angle grain boundaries through recrystallization/globularization enhanced by grain boundary sliding. In contrast, the Widmannstatten structure showed a rather poor hot-workability and a retarded refinement efficiency. The deformed microstructure was noticeably non-uniform and micro-textured at nearly all the compression conditions, though the recrystallized grain size was comparable with that of the martensite. To rationalize the distinct deformation behavior of the two starting microstructures, the underlying mechanisms governing the microstructure/orientation evolution were systematically analyzed and discussed. It was suggested that adopting martensite as the starting microstructure may be a potential approach to achieve the optimal microstructural breakdown effect for certain TiAl alloys.

Microstructure and Twinning in Ordered Orthorhombic Martensite in Rapidly Solidified Ti3Al-Nb Alloys

Microstructure Evolution of Rapidly Solidified Ti3al-2nb Alloy

Microstructure evolution of rapidly solidified tial alloys with various nb contents

Twinning behavior of orthorhombic-α" martensite in a Ti-7.5Mo alloy

Recent Electron Microscopy Results on Micro- and Nanostructured Ni-Ti-(X) Shape Memory Alloys

Structure and Martensitic Transformation in Rapidly Solidified CoNiAlFe Alloy

The Role of (001) Microtwinning Played During the Deformation of Stress Induced Martensite in Ti-Ni-Nb Shape Memory Alloy

The Role of High-Index Twinning on Hierarchical Α Microstructure in a Metastable Β Ti-5Al-5Mo-5V-3Cr Alloy

MICROSTRUCTURE AND INTERFACE STRUCTUREOF Ti_(36)Ni_(49)Hf_(15) HIGH TEMPERATURESHAPE MEMORY ALLOY

Crystallography Study on the Internal Twinning of Ti–Nb‐Based Shape Memory Alloys

High resolution electron microscopy studies on the interface structure of deformed stress induced martensite variants in a Ti–Ni–Nb shape memory alloy

A TEM Study on Thermally-Induced Martensitic Transformation in Ti44Ni47Nb9 Alloy

Evolution of dislocation and twin structures in Ti3Al during solidification

Microstructures, Martensitic Transformation, and Mechanical Behavior of Rapidly Solidified Ti-Ni-Hf and Ti-Ni-Si Shape Memory Alloys

Drastic enhancement in hot-workability and microstructural refinement of TiAl alloys via martensitic transformation: A comparative study

Stress-induced Crystallographic and Microstructural Evolution for Hierarchically Twinned Martensite in Single- and Dual-Phase Ni-Mn-Ga Alloys

Microstructure Transformation of a Refined High Nb Containing TiAl Alloy

MICROSTRUCTURE AND PHASE TRANSFORMATION DURING ANNEALING OF RAPIDLY SOLIDIFIED Al-Fe-Ti-C ALLOY

Lenticular Twinning Within Α’ Martensite in Ti-6Al-4V at Early Deformation Stage

The Role of Nano-domains in {1–011} Twinned Martensite in Metastable Titanium Alloys

Transmission electron microscopy study of the microstructure of B19 martensite in sputter-deposited Ti50.2Ni30Cu19.8 thin films