Abstract:This paper presents a sandwich structure for a capacitive pressure sensor. The sensor was fabricated by a simple three-mask process and sealed in vacuum by anodic bonding. The sensor, which utilizes a combined SiO/sub 2//Si/sub 3/N/sub 4/ layers as the elastic dielectric layers, exhibits high sensitivity. Mechanical characteristics of the sensor are theoretically analyzed based on a composite membrane theory and evaluated by use of finite element analysis (FEA). Square membrane sensors with side lengths of 800 /spl mu/m, 1000 /spl mu/m, 1200 /spl mu/m, and 1500 /spl mu/m were fabricated, providing a measured sensitivity of 0.08 pF/kPa, 0.12 pF/kPa, 0.15 pF/kPa, and 0.2 pF/kPa, respectively. The nonlinearity of the sensor is less than 1.2% over a dynamic range 80-106 kPa and the maximum hysteresis is about 3.3% to the full scale capacitance change. The TCO at 101 kPa is 1923 ppm//spl deg/C. All the electrodes of the sensor are leaded from the top side of the chip. Residual pressure in the sealed cavity at room temperature is evaluated by a pressure scanning test, indicating about 8 kPa. Comparison of experimental results with theoretical analysis shows that change of capacitance for the sandwich structure under pressure is mainly due to variation of the dielectric constant while geometric variations such as the area change of electrodes and the thickness change of dielectric layers is about two orders less than the variation of the dielectric constant. Sensitivity enhancements for the sensor are qualitatively discussed based on the physical effects of strained dielectrics, including electrostriction and flexoelectricity. [1551].

Design, Fabrication and Test of a Monolithic Capacitive Pressure Sensor

A novel monolithic CMOS capacitive pressure sensor

A Capacitive Pressure Sensor with Adjustable Working Range for Deep Sea

A Fully Integrated Capacitive Pressure Sensor with High Sensitivity

Design of A Novel CMOS Capacitive Absolute Pressure Sensor

A MEMS capacitive pressure sensor compatible with CMOS process

Design of the Interface Circuit for Monolithic MEMS Capacitive Pressure Sensor

The Design of a High Precision Capacitive Pressure Sensor Based on Comb Electrode

Modeling, Design and Fabrication of a Triple-Layered Capacitive Pressure Sensor

A Novel Capacitive Pressure Sensor Based on Sandwich Structures

Fabrication and Testing of Capacitive Pressure Microsensor

Design and simulation of integrated CMOS-compatible capacitive absolute pressure-sensing microsystems

Study on a novel capacitive pressure sensor

A novel capacitive barometric pressure sensor based on the standard CMOS process

Study of a Novel Capacitive Pressure Sensor Using Spiral Comb Electrodes

A Capacitive Pressure Sensor Based on LTCC/PDMS Bonding Technology

A Novel Capacitive Pressure Sensor Based on Non-Coplanar Comb Electrodes

A Capacitve Pressure Sensor with a Novel Multi-Layered Composite Membrane Strucutre Fabricated by a Three-Mask Process

Design and Fabrication of a MEMS Capacitance Vacuum Sensor Based on Silicon Buffer Block

A Silicon Directly Bonded Capacitive Absolute Pressure Sensor

A New Strategy for the Fabrication of a Flexible and Highly Sensitive Capacitive Pressure Sensor