Abstract:An attempt is made in this study to research the performance of prestressed concrete pipe piles based on 10,333 pile tests. Short and medium-length piles with slenderness ratios ranging from 10 to 90 are most widely used, and the optimal length is between the range of 10~50 m. For the same bearing stratum and diameter, the capacity of pile increases with increasing pile length until a limiting value is achieved. The average pile-top settlement is approximately in the range of 10 ~ 25 mm, and the rebound rates for piles with various lengths are similar. The results show that the diameter of Φ400 and Φ500 is most widely used, accounting for 33.8% and 46.1%, respectively, and the optimal length is between the range of 10 ~ 50 m. Under conditions of, when the bearing stratum is clay, the bearing capacity of pipe piles increases with an increase in length to diameter ratio; when sandy soil, the bearing capacity firstly increases and then decreases; when with the same length to diameter ratio, the bearing capacity increases in both cases, and the latter is higher than the former. There is a large discreteness in settlement of pile top, and the average value is normally about 10 ~ 25 mm, without significant relationship with the bearing stratum. The results of statistical research will be a reliable reference for pipe pile research, design and construction in soft soil area. The results are expected to improve the understanding of prestressed concrete pipe piles and facilitate the design process.

A Simplified Calculation Method for Ultimate Bearing Capacity of Cast-in-Place Concrete Pipe Pile with Large Diameter in Clay Soil

Assessment of design methods for axial bearing capacity of driven piles in clay

Statistical research on performance of prestressed concrete pipe piles

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

A NEW CALCULATION METHOD FOR LARGE-DIAMETER-TUBULAR-PILE BEARING CAPACITY

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

RESEARCH ON INFLUENCE OF SOIL CORE ON BEARING CHARACTER OF LARGE-DIAMETER TUBULAR PILE USING CAST-IN-SITU CONCRETE

A kind of approximate method for nonlinear collaboration analysis of quasi-rigid foundation-piles-soil system

Elastoplastic Analytical Computation of Long Piles under Combined Lateral Loads

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Analysis of Axial Load-Transfer of Large-Diameter Cast-in-situ Tubular Pile

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Influence of Soil Reinforcement on the Uplift Bearing Capacity of a Pre-Stressed High-Strength Concrete Pile Embedded in Clayey Soil

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

A simplified approach to calculating settlement of a single pre-bored grouting planted nodular pile in layered soils

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles