Abstract:High dense Al4SiC4–SiC ceramic composites with different SiC contents were hot pressed using self-synthesized Al4SiC4 and commercial SiC powders without any sintering additives. The effect of SiC contents on the densification, microstructure, and mechanical properties of Al4SiC4-based ceramics was investigated. The anisotropic growth of Al4SiC4 grains was inhibited by the pinning effect of the introduced SiC particles, while the weakly bonded interfaces were formed due to the thermal expansion mismatch between Al4SiC4 and SiC. As a consequence, the mechanical properties of Al4SiC4-based ceramics were improved significantly. With the SiC contents increasing from 0 to 30 wt%, the flexural strength increased from 314 ± 7 to 466 ± 18 MPa and the fracture toughness increased from 4.8 ± 0.4 to 7.3 ± 0.3 MPa m1/2, respectively. The flexural strengths of Al4SiC4–SiC composites at elevated temperatures were also tested under an argon atmosphere. No strength degradation of Al4SiC4–SiC composites was observed at 1200 °C and a high strength retention rate of 96.3 % at 1400 °C was obtained. The above results demonstrate the application prospects of Al4SiC4–SiC ceramics as high-temperature structural materials.

Microstructures and Mechanical Properties of Pressureless Sintered Ca-3(PO4)(2)/Si3N4 Composite Ceramics

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Mechanical Properties of Ceramic–metal Composites by Pressure Infiltration of Metal into Porous Ceramics

Microstructure and Mechanical Properties of Three Porous Si3n4 Ceramics Fabricated by Different Techniques

Effects of Sintering Additive and Β-Si3n4 Phase Contents on the Properties of Porous Si3N4 Ceramics

Microwave Sintering of Si3N4 Ceramics

Microstructure and Properties of Porous Si3N4 Ceramics Fabricated by Gelcasting

Mechanical Properties and Toughening Mechanisms of Si3n4 Matrix Laminated Ceramic Composite

Mechanical Properties and Toughening Mechanisms of Si 3 N 4 Matrix Laminated Ceramic Composite

Study on the mechanical properties and microstructure of Al2O3/nano-SiC multiphase ceramics

Preparation And Properties Of High Strength Porous Si3n4 Ceramics

POROUS Si3N4-SiO2 COMPOSITE CERAMIC AND ITS PROPERTIES

Effects of Sintering Temperature on Microstructure and Performances of Micro-Porous Si_3N_4 Ceramics

Study on Microstructure and Mechanical Properties of Porous Si<sub>3</sub>N<sub>4</sub> Ceramics

Microstructure and Mechanical Properties of Hot-Pressed Al2O3–mullite–ZrO2–SiC Composites

Effects of SiC contents on the microstructure and mechanical properties of Al4SiC4–SiC ceramic composites

Fabrication of Si3N4 Ceramics with High Thermal Conductivity and Flexural Strength Via Novel Two-Step Gas-Pressure Sintering

Study on Micro-structure and Properties of Al2O3/SiC Ceramics by Pressureless Sintering in Air

Si3N4-SiC ceramic nanocomposites

Microstructure and properties of porous Si3N4 ceramics by gelcasting-self-propagating high-temperature synthesis (SHS)

Study on microstructure and mechanical properties of porous Si3N4 ceramics