Abstract:In current practice, DRAM manufacturers apply redundancy repair to decommission all the weak cells that cannot satisfy the target data retention time under the worse-case operational conditions (e.g., the highest operating temperature). However, as the DRAM scaling enters sub-20nm regime, it becomes increasingly challenging to repair all the weak cells at reasonable cost. This work studies how one could use DRAM chips with unrepaired weak cells in computing systems. In particular, this work is based upon the simple idea that OS reserves all the error-prone pages, which contain at least one unrepaired weak cell, from being used. Under a relatively high error-prone page rate (e.g., 8%), this basic idea is subject to two issues: (1) Simply reserving all the error prone pages could make it almost impossible for OS to allocate a continuous fragmentation-free physical memory space for some critical operations such as OS booting and DMA buffering. (2) Since most error-prone pages may only contain few unrepaired weak cells, reserving all the error-prone pages from practical usage could cause noticeable memory resource waste. Aiming to address these issues, this paper presents a controller-based selective page re-mapping strategy to ensure a continuous critical memory region for OS, and develops a software-based memory error tolerance scheme to re-cycle all the error-prone pages for the zRAM function in Linux. Since the first scheme only eliminates the fragmentation in the critical memory region (e.g., 128MB in Linux), the remaining non-critical memory region is still subject to severe fragmentation. Hence, we carried out experiments using SPEC CPU2006 to quantitatively demonstrate that highly fragmented non-critical memory region may not cause significant computing system performance degradation. We further study the latency and hardware cost of implementing the controller-based page re-mapping, and the effectiveness of re-cycling error-prone pages for zRAM in Linux. The experimental results show that our proposed software-based error tolerance scheme degrades the speed performance of zRAM by only up to 7%.

Memory Built-In Self-Repair Method Based on Address Partitioning Strategy

Efficient built-in self-repair strategy for embedded SRAM with selectable redundancy

A built-in self-repair design for RAMs with 2-D redundancy

Cost-efficient built-in repair analysis for embedded memories with on-chip ECC

A new built-in self-repair approach to VLSI memory yield enhancement by using neural-type circuits

An on-line BIST RAM architecture with self-repair capabilities

Design and Verification of SRAM Self-Detection Repair Based on ECC and BISR Circuit

On the Use of Dram with Unrepaired Weak Cells in Computing Systems

A BISR Scheme for 3D Stacked Memory by Sharing Adjacent Redundancy Cells Across Dies

A Hybrid Main Memory Architecture Design for Reducing DRAM System Refresh Power

Exploring Dynamic Redundancy to Resuscitate Faulty PCM Blocks

Deep Q-Learning with Bit-Swapping-Based Linear Feedback Shift Register fostered Built-In Self-Test and Built-In Self-Repair for SRAM

Architectural Exploration to Address the Reliability Challenges for ReRAM-Based Buffer in SSD

Impacts of Memory Address Mapping Scheme on Reducing DRAM Self-Refresh Power for Mobile Computing Devices

RRAM Repair Scheme Based on RRAM Cell Characteristics

Bit-Level Disturbance-Aware Memory Partitioning for Parallel Data Access for MLC STT-RAM

Aegis: partitioning data block for efficient recovery of stuck-at-faults in phase change memory.

Fault clustering technique for 3D memory BISR.

A fault-tolerant program memory unit for on-board computer

Logic-DRAM co-design to efficiently repair stacked DRAM with unused spares

Logic-DRAM Co-Design to Exploit the Efficient Repair Technique for Stacked DRAM