Abstract:In current practice, DRAM manufacturers apply redundancy repair to decommission all the weak cells that cannot satisfy the target data retention time under the worse-case operational conditions (e.g., the highest operating temperature). However, as the DRAM scaling enters sub-20nm regime, it becomes increasingly challenging to repair all the weak cells at reasonable cost. This work studies how one could use DRAM chips with unrepaired weak cells in computing systems. In particular, this work is based upon the simple idea that OS reserves all the error-prone pages, which contain at least one unrepaired weak cell, from being used. Under a relatively high error-prone page rate (e.g., 8%), this basic idea is subject to two issues: (1) Simply reserving all the error prone pages could make it almost impossible for OS to allocate a continuous fragmentation-free physical memory space for some critical operations such as OS booting and DMA buffering. (2) Since most error-prone pages may only contain few unrepaired weak cells, reserving all the error-prone pages from practical usage could cause noticeable memory resource waste. Aiming to address these issues, this paper presents a controller-based selective page re-mapping strategy to ensure a continuous critical memory region for OS, and develops a software-based memory error tolerance scheme to re-cycle all the error-prone pages for the zRAM function in Linux. Since the first scheme only eliminates the fragmentation in the critical memory region (e.g., 128MB in Linux), the remaining non-critical memory region is still subject to severe fragmentation. Hence, we carried out experiments using SPEC CPU2006 to quantitatively demonstrate that highly fragmented non-critical memory region may not cause significant computing system performance degradation. We further study the latency and hardware cost of implementing the controller-based page re-mapping, and the effectiveness of re-cycling error-prone pages for zRAM in Linux. The experimental results show that our proposed software-based error tolerance scheme degrades the speed performance of zRAM by only up to 7%.

DQN based page allocation for ReRAM main memory

On the Use of Dram with Unrepaired Weak Cells in Computing Systems

An RRAM Retention Prediction Framework Using a Convolutional Neural Network Based on Relaxation Behavior

SEAL-lab Technical Report – No . 2015-001 ( April 29 , 2016 ) Processing-in-Memory in ReRAM-based Main Memory

SEAL-lab Technical Report – No . 2015-001 ( November 30 , 2015 ) Processing-in-Memory in ReRAM-based Main Memory

Rank-Aware Dynamic Migrations and Adaptive Demotions for DRAM Power Management

An experimental study on the potential use of ReRAM as SSD buffer

A Software-hardware Collaborating Framework for Wear Leveling on Phase Change Memory

Efficient page caching algorithm with prediction and migration for a hybrid main memory

Energy Efficient Real-Time Task Scheduling for Embedded Systems with Hybrid Main Memory

Architectural Exploration to Address the Reliability Challenges for ReRAM-Based Buffer in SSD

Exploring Dynamic Redundancy to Resuscitate Faulty PCM Blocks

A Hybrid Main Memory Architecture Design for Reducing DRAM System Refresh Power

Optimal task allocation on non-volatile memory based hybrid main memory

Cross-layer Designs against Non-ideal Effects in ReRAM-based Processing-in-Memory System

A Novel Page Replacement Algorithm for the Hybrid Memory Architecture Involving PCM and DRAM.

Adaptive Weight Mapping Strategy to Address the Parasitic Effects for ReRAM-based Neural Networks

DReAM: Dynamic Re-arrangement of Address Mapping to Improve the Performance of DRAMs

Efficient Reinforcement Learning On Passive RRAM Crossbar Array

Task Allocation on Nonvolatile-Memory-Based Hybrid Main Memory

A Hybrid-Grained Remapping Defense Scheme Against Hard Failures for Row-Column-NVM