Abstract:High-quality zeolite silicalite-1 membranes with a large area (78.5cm2) were successfully prepared on porous, tubular stainless steel (PTSS) supports with optimized synthesis solution composition by a two-stage varying-temperature in situ synthesis. Compared with the synthesis at constant temperature (one-stage), the two-stage varying-temperature in situ synthesis (TSVTS) generated a thin and dense membrane, since a large number of new nuclei could form at low temperature, while the crystallization temperature was rapidly changed to a high temperature after completion of the nucleation period, a thin and continuous membrane would quickly formed on the support by the nuclei regrowth. The membranes were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM) and single-gas permeation. These results indicate that the membranes prepared by the TSVTS method exhibit high gas permeation performance and good reproducibility. H2 permeance and H2/n-C4H10 selectivity of the membranes by TSVTS method reached to 12.25×10−7mol/(m2sPa) and 46.1, respectively. And the yield of high-quality membranes with perm-selectivity of H2/n-C4H10 larger than 25 (which is almost five times as large as the Knudsen factor) as a quality criterion reached to 70% of all preparations. By comparison of their permeability and reproducibility with those reported in the literature, it was revealed that the prepared membranes by TSVTS method were of good quality. Moreover, their thermal stability were tested in a gas mixture of ethylbenzene and hydrogen at high temperature, for an example, the membrane having the separation selectivity of hydrogen and ethylbenzene mixture as high as 190 is stable after 80h of run at 400°C, suggesting the membrane is thermally durable for long time operation.

Effects of aging on the synthesis and performance of silicalite membranes on silica tubes without seeding

Preparation of Mordenite Composite Membranes with Seeding

Effects of the synthesis hydrogel on the formation of zeolite LTA membranes

Synthesis of Silicalite-1 Membrane with High-Thermal Stability on Silica Tubes by<i> In Situ</i> Hydrothermal Synthesis

Preparation of zeolite MFI membranes on alumina hollow fibers with high flux for pervaporation

The influence of nanoseeds on the pervaporation performance of MFI-type zeolite membranes on hollow fibers

Preparation of high-performance zeolite NaA membranes in clear solution by adding SiO2 into Al2O3 hollow-fiber precursor

A Novel Method to Synthesize High Performance Silicalite-1 Membrane

Preparation of silicalite-1 zeolite membrane on porous α-Al2O3 tube by modified secondary growth method and its characterization

The preparation of zeolite NaA membranes on the inner surface of hollow fiber supports

Synthesis of silicalite-1 membrane with two silicon source by secondary growth method and its pervaporation performance

Preparation and characterization of silicalite-1 membrane by counter-diffusion secondary growth

Preparation of Zeolite NaA Membranes on Macroporous Alumina Supports by Secondary Growth of Gel Layers

Preparation of zeolite MFI membranes on defective macroporous alumina supports by a novel wetting–rubbing seeding method: Role of wetting agent

Synthesis and property of silicalite-1 membranes by restricting growth method with dilute solution

Manipulation of the Surface Microstructure and Its Effects on the Flux of NaA Zeolite Membranes in Pervaporation

Preparation of Microfibrous Supported Silicalite-1 Zeolite Membrane by Secondary Growth Method

Microstructure Manipulation of MFI-type Zeolite Membranes on Hollow Fibers for Ethanol–water Separation

Preparation of Silicalite-1 Membranes on Stainless Steel Supports by a Two-Stage Varying-Temperature in Situ Synthesis

Preparation and Pervaporation Performance of Silicalite-1 Zeolite Membrane with a Two-stage Temperature-varied Hydrothermal Technique

Synthesis and structural analysis of Silicalite-1 membranes by coating technique with nanosized seed