Intermetallic Compound Formation in Sn-Co-Cu, Sn-Ag-Cu and Eutectic Sn-Cu Solder Joints on Electroless Ni(P) Immersion Au Surface Finish after Reflow Soldering

Peng Sun,Cristina Andersson,Xicheng Wei,Zhaonian Cheng,Dongkai Shangguan,Johan Liu

DOI: https://doi.org/10.1016/j.mseb.2006.08.051

IF: 3.407

2006-01-01

Materials Science and Engineering B

Abstract:The interfacial reactions between Sn–0.4Co–0.7Cu eutectic alloy and immersion Au/electroless Ni(P)/Cu substrate were investigated after reflow soldering at 260°C for 2min. Common Sn–4.0Ag–0.5Cu and eutectic Sn–0.7Cu solders were used as reference. Two types of intermetallic compounds (IMC) were found in the solder matrix of the Sn–0.4Co–0.7Cu alloy, namely coarser CoSn2 and finer Cu6Sn5 particles, while only one ternary (Cu, Ni)6Sn5 interfacial compound was detected between the solder alloy and the electroless nickel and immersion gold (ENIG) coated substrate. The same trend was also observed for the Sn–Ag–Cu and Sn–Cu solder joints. Compared with the CoSn2 particles found in the Sn–Co–Cu solder and the Ag3Sn particles found in the Sn–Ag–Cu solder, the Cu6Sn5 particles found in both solder systems exhibited finer structure and more uniform distribution. It was noted that the thickness of the interfacial IMCs for the Sn–Co–Cu, Sn–Ag–Cu and Sn–Cu alloys was 3.5μm, 4.3μm and 4.1μm, respectively, as a result of longer reflow time above the alloy's melting temperature since the Sn–Ag–Cu solder alloy has the lowest melting point.