Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

INFLUENCES OF EDGING ROLL SHAPE ON THE PLASTIC STRAIN DISTRIBUTION OF SLAB DURING MULTI-PASS V-H ROLLING PROCESS

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Influence of Groove Fillet Radii of Edger Roll on Slab Deformation

The Cracks on Slab Corner During Hot Rolling Process

SIMULATION OF STEADY STATE SLAB EDGING WITH 3D RIGID-PLASTIC FEM

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

The central strain analytical modeling and analysis for the plate rolling process

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

FINITE ELEMENT ANALYSIS OF STEADY STATE HV ROLLING PROCESS OF SLAB

The theoretical model of the effective strain establishment for the plate during the snake rolling

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Influence of Roll Smoothing on the Initial Residual Stress Fields of 10ni5crmov Steel Heavy Gauge Plates

Finite Element Analysis of Large Plastic Deformation Process of Pure Molybdenum Plate During Hot Rolling

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Simulation of Rolling Process on 4-High CVC Hot Strip Continuous Mills

A coupling model of vertical rolling process based on upper bound method and elastic theory

Influences of Friction Condition and End Shape of Billet on Convex at Root of Spline by Rolling with Round Dies

An Efficient Multi-Scale Modeling Method that Reveals Coupled Effects Between Surface Roughness and Roll-Stack Deformation in Cold Sheet Rolling

SURFACE PLASTIC DEFORMATION REGULARITY AND MICROSTRUCTURAL EVOLUTION IN THE COMPOUND ROLLING OF Q235 BILLET

Effects of rolling parameters of snake hot rolling on strain distribution of aluminum alloy 7075

Surface plastic deformation distribution and microstructural evolution in the compound rolling of Ti–50Al billet