Abstract:The thread and spline synchronous rolling (TSSR) process is a new developed rolling process, which can form the different profiles simultaneously in the process and can ensure the consistency of the relative position of different profiles of parts. However, the multi-meshing motions are intercoupling and the multi-deformation characteristics are intercoupling during the forming process. It can easily result in dimension overshoot, and even does not make the synchronous rolling process go smoothly. Exploring the influence of controllable processing parameters on the synchronous rolling process, especially the geometric parameters of rolled parts, is helpful to determine the parameters and control the size error for a smooth rolling process. Thus, in this paper, the effects of controllable geometric parameters and motion parameters such as billet diameter, radial feed-in speed, and rotational speed of synchronous rolling die on the TSSR process have been studied. The synchronous rolling experimental scheme was determined using an orthogonal experimental design method, and the geometric parameters of different tooth profiles of rolled parts were measured and analyzed. The experimental results indicated that: the uncoordinated meshing movement between different tooth profiles is more likely to cause tooth error of the splined section of the part; variations of the processing parameters are more likely to cause fluctuations in the size of the splined section of the part, and change of the billet diameter mainly affects the outside diameter of the threaded and splined sections, and the threaded and splined pitches are mainly affected by the motion parameters of the synchronous rolling die; the motion parameters of the rolling die should be matched and the lower rotational speed needs to match the lower radial feed-in amount per revolution; the ideal dimensional accuracy can be obtained by using an appropriate processing parameter combination, for example, the pitch error of the splined section of the part is less than 0.5 μm under one set of experimental conditions in this paper.

Influences of Friction Condition and End Shape of Billet on Convex at Root of Spline by Rolling with Round Dies

A Friction Evaluation Method Based on Barrel Compression Test

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

Rotatory Condition at Initial Stage of External Spline Rolling

Finite element modeling and analysis for the integration–rolling–extrusion process of spline shaft

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Motion Characteristic Between Die and Workpiece in Spline Rolling Process with Round Dies

Formation of concavities on the ends of parts manufactured on CNC skew rolling mills

Study on near-net forming technology for bars by axial feed skew rolling based on taper-end billets

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Improvement of Axial Forging Process for Spline Shaft by Die Design

Comparative Studies on a Chamfer Technology and a Convex Roll Technology During the Soft Reduction Process

Study and improvements on the rolling loads of axial incremental rolling process for spline shaft based on finite element method

Influence of geometric parameters on variation of motion during rolling process of involute spline

Metal flowing of involute spline cold roll-beating forming

New method for forming shaft having thread and spline by rolling with round dies

Numerical and experimental study of the taper-rolling process for producing a helical blade from a metal strip

Process Parameter Determination of the Axial-Pushed Incremental Rolling Process of Spline Shaft

The Design and Simulation of Roller for Machining Involute Spline

The Experimental Study of Axial In-feed Incremental Rolling Process of Spline Shaft

Influence of Processing Parameters on the Thread and Spline Synchronous Rolling Process: an Experimental Study.