Abstract:The process parameters of the axial-pushed incremental rolling process are studied in this paper to solve the problems in present production process of spline shaft. Firstly, the principle of the axial-pushed incremental rolling process is introduced. Based on the material of 42CrMo, the simplified finite element models of the process are established up. Then, the effects of process parameters and the material flow behavior during the process are investigated by finite element analysis (FEA). After that, the reasonable process parameters during the novel process (die angle 9°, feed speed 0.5 mm s−1, and speed of rolling die 25 r min−1) are determined to meet a good balance between the forming force, product precision, and processing efficiency. To verify the determined parameters, validation tests with the blank material 42CrMo were carried out on an axial-pushed incremental rolling equipment. The experimental results (tooth shape and forming force) show a good agreement with FEA results. Through the dimension measurement, the addendum and root circle diameters of formed spline shafts are 51.61, 51.72, and 51.66 mm and 48.66, 48.78, and 48.69 mm, respectively. The formed spline shafts with the determined process parameters reach to the requirement of direct use (required addendum circle diameter 51.56~51.75 mm, required root circle diameter 48.5~48.7 mm). Finally, the feasibility of the determined process parameters with other materials (no. 20 and no. 45 steel) is investigated. The dimensions of the formed spline shafts just slightly deviate from the theoretical value. This problem is solved by adjusting the feed speed and the speed of rolling die. Therefore, the determined process parameters of the axial-pushed incremental rolling process are usable for the production of spline shaft.

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Study on Warm Forming Effects of the Axial-Pushed Incremental Rolling Process of Spline Shaft with 42crmo Steel

Deformation Mechanism and Performance Improvement of Spline Shaft with 42crmo Steel by Axial-Infeed Incremental Rolling Process

Process Parameter Determination of the Axial-Pushed Incremental Rolling Process of Spline Shaft

Experimental Study on the Axial-Infeed Incremental Warm Rolling Process for Spline Shaft Production

Study on the Material Characteristic and Process Parameters of the Open-Die Warm Extrusion Process of Spline Shaft with 42crmo Steel

Study on the improvements of incremental rolling process for spline shaft with round tools based on finite element method

Finite element modeling and analysis for the integration–rolling–extrusion process of spline shaft

Improvement of Axial Forging Process for Spline Shaft by Die Design

Study and improvements on the rolling loads of axial incremental rolling process for spline shaft based on finite element method

Research on Divided Flow Method and Temperature Effect of the Incremental Rolling Forming Process for Spline Shaft

The Experimental Study of Axial In-feed Incremental Rolling Process of Spline Shaft

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Numerical Analysis on the Power-Type Incremental Rolling Forming Process of Spline Shaft

Metal flowing of involute spline cold roll-beating forming

A Novel Multipass Incremental Gear Rolling Process with Blank and Rolling Die Axes Crossed

Deformation Characteristics of Self-Infeed Rolling Process for Thread Shaft

Diameter Calculation of Billet Before Incremental Rolling for Spline Shaft and Finite Element Analysis

A new method of rolling finishing forming process of spiral bevel gears investigated by numerical simulation and experiment

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk