Abstract:The red-emitting Sr2Si5N8:Eu2+ phosphor with a superior quantum efficiency and suitable emission spectrum has been widely used as a promising down-conversion material in white light-emitting diodes. However, its thermal degradation under high temperature handicaps its large scale application, and therefore must be reduced. Here, we proposed to increase the thermal stability of Sr2Si5N8:Eu2+ by coating a nanometer-order Al2O3 film on each phosphor particle using an atomic layer deposition approach in a fluidized bed reactor. The deposited Al2O3 layer was quite uniform and conformal when using O-3 as the oxidizer, and its thickness could be controlled by the dosage type, deposition temperature and cycle numbers, which largely affects the photoluminescence properties and thermal degradation of the title phosphor. Thermal gravimetric analysis results showed that the oxidation temperature of the coated phosphor increased from 700 to 850 degrees C, suggesting that the coating layer has the function of anti-oxidation. Meanwhile, the coated phosphor particle surface became hydrophobic. Consequently, the thermal degradation of phosphor powders in air at 200 degrees C was greatly reduced and the stability of the fabricated LEDs with coated powders was also improved. Prospectively, the proposed approach provides a new strategy to improve the thermal stability of other phosphors.

Visualization of thermally-activated degradation pathways of tris(8-hydroxyquinoline) aluminum thin films for electroluminescence application

Real-time Visualization of Thermally Activated Degradation of the ITO/CuPC/NPB/Alq3 Stack Used in One of the Organic Light-Emitting Diodes

Thickness Dependent Behavior of Photoluminescence of Tris(8-hydroxyquinoline) Aluminum Film

Nanoscale Investigation of Moisture-Induced Degradation Mechanisms of Tris(8-Hydroxyquinoline) Aluminium-Based Organic Light-Emitting Diodes

Study on Temperature Characteristics of Organic Light-Emitting Diodes Based on Tris-(8-hydroxylquinoline)-aluminum

Pulsed laser deposition of aluminum tris-8-hydroxyquinline thin films

Metal-Induced Photoluminescence Quenching Of Tri-(8-Hydroxyquinoline) Aluminum

Preparation and characterization of CuAlO 2 transparent thin films prepared by chemical solution deposition method

The Evolution of Alq3 Films Exposure to Air

Preparation and characterization of CuAlO<sub>2</sub> transparent thin films prepared by chemical solution deposition method

Visualization of Thermally Activated Morphology Evolution of N, N’-di(naphthalene-1-yl)- N, N’-diphthalbenzidine Films on ITO/copper Phthalocyanine Underlying Layer

Highly Transparent and Conductive Zn0.85Mg0.15O:Al Thin Films Prepared by Pulsed Laser Deposition

Thermal stability of amorphous InGaZnO thin film transistors passivated by AlO x layers

Testing the physical properties stability of Zinc (8-hydroxyquinoline) thin films toward stable photodetection performance: Effect of annealing

Enhanced Thermal Degradation Stability of the Sr2Si5N8:Eu2+ Phosphor by Ultra-Thin Al2O3 Coating Through the Atomic Layer Deposition Technique in a Fluidized Bed Reactor

Evaporated CuAl Amorphous Alloys and Their Phase Transition

Comprehensive microstructural and optical characterization of the thermal stability of aluminum-titanium oxynitride thin films after high temperature annealing in air

Annealing, Oxidation and Electronic Structure of Alq3 Film Doped with Rubidium

Nanoscale investigation on nature of dark hole in moisture-exposed tris(8-hydroxyquinoline) aluminum thin films

Annealing Treatment on Amorphous InAlZnO Films for Thin-Film Transistors

Rf Magnetron Sputtered Zno : Al Thin Films on Glass Substrates: A Study of Damp Heat Stability on Their Optical and Electrical Properties