Abstract:Ferritic stainless steels are candidate interconnect materials for solid oxide fuel cells (SOFC); however, the oxidation resistance of commercial stainless steels within the operating temperature range of 700–800°C is not adequate. A relatively thick, poorly conducting oxide layer forms on the surface of the stainless steel interconnect, decreasing cell performance. One way of modifying the oxidation behaviour of an alloy is through surface treatment. The aim of this work is to perform a systematic study of the effect of surface treatment (sandblasting and cold rolling) on the oxidation behaviour of three different ferritic stainless steels at 800°C in air. Oxidized specimens are characterized using X-ray diffraction (XRD) and scanning electron microscopy (SEM). In addition, specimens oxidized under the same conditions for 15min are examined using secondary ion mass spectrometry (SIMS) depth profiling and X-ray photoelectron spectroscopy (XPS) depth profiling.For all three steels, the as-is (undeformed) specimens have a lower mass gain than the deformed specimens. The steel with the highest Cr content has significantly higher mass gains than the other two steels, which have similar mass gains. X-ray diffraction and electron microscopy results indicate that the oxide scale formed on all the specimens consists of an inner layer of chromia and an outer spinel layer. The relative amounts of the two oxide phases present depends on both the steel and treatment condition. The presence of insulating oxides at the metal/oxide interface is detected with both surface science techniques and electron microscopy.

Oxide Scale Formation and Stability of Fe–Cr Alloy Interconnects under Dual Atmospheres and Current Flow Conditions for SOFCs

Microstructural and micromechanical characterization of intergranular oxidation in Fe-15Cr alloy

Metallic interconnects for solid oxide fuel cell: Performance of reactive element oxide coating during long time exposure

Cr-Based Alloy Used as Interconnect in Solid Oxide Fuel Cells

Thermal conversion and evolution behavior of surface scale on SOFC interconnect steel with sputtered FeCoNi coating

Metallic Interconnects for Solid Oxide Fuel Cell: Performance of Reactive Element Oxide Coating During 10, 20 and 30 Months Exposure

Properties of Fe–Cr Based Alloys As Interconnects in a Solid Oxide Fuel Cell

Iron oxide fluxing and precipitation in sulphate deposits during heat-resistant alloy corrosion in simulated combustion gas

Initial stage oxidation corrosion of commercial ferritic stainless steels with different Cr contents at 650 °C for solid oxide fuel cells

Characterization of La0.8Sr0.2Co0.5Mn0.5O3-δ Coating on Alloy Interconnect in SOFC

High Temperature Oxidation of Fe-Cr Alloys in Atmospheres Containing 2.0 % SO2+5.0 % O2

High-Temperature Oxidation Properties and Microstructural Evolution of Nanostructure Fe-Cr-Al ODS Alloys

The effect of surface treatment on the oxidation of ferritic stainless steels used for solid oxide fuel cell interconnects

Fabricating a MnCo coating to improve oxidation resistance and electrical conductivity of Crofer22H alloy as SOFC interconnect

Mechanical reliability and life prediction of coated metallic interconnects within solid oxide fuel cells

The Preparation and Properties of Ti(Nb)-Si-C Coating on the Pre-Oxidized Ferritic Stainless Steel for Solid Oxide Fuel Cell Interconnect

An investigation of Cr vaporization from SUS430 metallic interconnect and deposition on (La,Sr)MnO 3 cathode of intermediate temperature solid oxide fuel cells

High-entropy FeCoNiMnCu alloy coating on ferritic stainless steel for solid oxide fuel cell interconnects

Experimental Investigation of the Initial Stage of the Oxidation Mechanism of Co Coating for Solid Oxide Fuel Cell Interconnects at 650 °C

Oxidation behavior of a Ni-Fe support in SOFC anode atmosphere

Oxidation behavior and interface diffusion of porous metal supported SOFCs with all plasma sprayed functional layers in air at 650oC