Abstract:Fine-grained metals have attracted much interest due to the possibility to obtain both high strength and high ductility.Studies of the deformation mechanisms in fine-grained metals are therefore important,and can also help fill a gap in knowledge between nano-grained metals and conventional coarse-grained metals,which is an area of both scientific and industrial interest.For such an investigation it is very important to use a starting material with a simple microstructure.For this purpose spark plasma sintering(SPS) has been used to prepare samples of fully dense,fine-grained Al with average grain sizes ranging from 0.8μm to 5.2μm,in a fully recrystallized condition,with equiaxed grains and a random texture.The microstructures and mechanical properties of these sintered finegrained Al samples have been studied using EBSD,TEM and compression testing.Based on these studies,relationships between the microstructure and mechanical properties have been established. The results show that the formation of deformation microstructure depends on grain size.During deformation,all grains in samples with an average grain size of 5.2μm show grain subdivision by dislocation boundary formation,though few grains in a sample with an average grain size of 0.8μm show dislocation boundary formation.The mechanical properties of fine-grained Al show a transition in behavior with decreasing average grain size.For samples with an average grain size of 1.3μm,stressstrain curves show yield drop phenomenon,attributed to source-limited hardening.For a sample with an average grain size of 0.8μm,the stress-strain curve shows only limited work-hardening after yielding,in agreement with the observation of the limited formation of dislocation boundaries inside grains during deformation.For a sample with average grain size of 5.2μm the average dislocation boundary misorientation angle increases more quickly than in deformed conventional coarse-grained Al deformed to the same strain,due to the effect of increased volume fraction of grain boundaries and oxide particles.The strength of the SPS-prepared Al samples is higher than found for samples with identical grain sizes prepared by thermo-mechanical deformation,due to the presence of oxide particles,and to source-limited hardening for samples with average grain sizes smaller than 1.3μm.

Study of the microstructure of low silica sinter with different carbon contents on grain size constitution by the fractal method

Study on Fractal Characteristics of Grain Size Distribution of Low Silica Sinter

The Fractal Research on Low Silicon Sinter

Multi-Fractal Behaviors in Grain Size Distribution of Low Silica Sinter

The Research on the Effective Factors of Quality Fractai Dmension of Low Silicon Sinter

Research on Size Distribution of Sinters with Different MgO Content

Calculation and Analysis of Multifractal Spectrum of Low Silicon Sinter

Multi-fractal Research on Pore Distribution of Low Silica Sinter with Different MgO Content

The Fractal Progress Research of Low Silicon Sinter

Multi-Tractional Research on Pore Distribution in Sintered Ore With Different Carbon

The Calculation of Fractal Dimension with Programm According to the Characters of the Sinter' SEM

Fractional Research on Granularity Distribution of Sinter with Different Basicity

Multi-Fractional Research on Pore Distribution in the Sinter Ore with Different Basicity

Study on Influence of Air Distribution in Sintering Process on Sinter Quality

Study of Metallurgical Properties in the Sintered Ore with Variable SiO<sub>2</sub>

Microstructure Evolution of Aluminum Powder During Sintering

Effect of Microstructure of Sinter with Different Indian Ore Proportion on Sintering Property

Study on Improving Intensity of Shigang′s Sinter

In situ investigation of the silicon carbide particles sintering

Influence of mineral structure on metallurgical properties of high basicity sinter

Microstructures and Mechanical Properties of Sintered Fine-Grained Al