Abstract:There exists internal connection between the process parameters and real sinter quality in the sintering process. However, few investigations on bridging the process parameters and real sinter quality for engineering applications were reported. For example, only process parameters (flow resistance, heat condition of sintering bed and off-gas composition) can be obtained by numerical method in the previous studies. Actual sinter strength and reducibility can’t be captured due to lacking of reliable models and the limited computing resource. This paper focused on solving the problem, which was substantial for parameters optimizing in both numerical simulation and on-line control of sinter quality. The melt quantity index (MQI), combining the peak temperature and duration time of melting temperature (DTMT), was used in this study. We also explained its physical significance as the effective “energy” for melting phase formation. Then the corresponding relation between MQI and sinter yield was widely confirmed by our own experimental data and the reproduced data from published references. Consequently, the MQI was recommended as a wise indicator of real sinter strength. The effects of three operating parameters (fixed carbon content, sintering pressure and fuel reactivity) on sinter strength were investigated by examining the MQI, sintering speed and air flowrate. Besides, the influencing mechanism of two important performance parameters (combustion and heat utilization efficiencies) on MQI was clarified. The monitoring of the above parameters would provide a powerful support for the transparency of sintering process “black-box” and optimization of operating parameters. Finally, a conceptual design for the on-line control of sinter strength was even proposed based on the present results.

Study on Influence of Air Distribution in Sintering Process on Sinter Quality

Affection of heat preservation system on surface layer sinter quality

EXPERIMENT STUDY ON THE EFFECT OF IRON ORE SINTER BEHAVIOR WITH ADDING BIOMASS

Sintering test research with addition of hematite concentrate

Comprehensive Improving Technology for Air Leakage on Sintering System

Experimental Study on Effect of Flux Addition on the Sintering Harmful Gas Emission

Study on Optimizing the Sintering Proportioning in Masteel

Simulation of temperature field of sintering ignition furnace

Experimental study of the ventilation volume’s influence on the composition of sintering flue gas

An Experimental Investigation Oil Optimization of Technological Parameters of Sintering Process in Xuanhua Iron & Steel Co.

Sinter Strength Evaluation Using Process Parameters under Different Conditions in Iron Ore Sintering Process

Study on Improving Intensity of Shigang′s Sinter

THE EFFECT OF HEATING METHOD TO SINTERING PROCESS OF PURE METAL POWDERS

Influence of oxygen-rich hot air composite gas medium on sintering performance and function mechanism

Research on effect of premixing pulverized coal and lime on sintering flue gas emission

Study on Influencing Factors of High-Temperature Basic Characteristics of Iron Ore Powder and Optimization of Ore Blending

Experimental Research on Enhancing Strength Index of Sintering Ore at Tangshan Iron and Steel Co.

Simulation of the Internal Temperature Field and Flow Field in a Double-Layer Sintering Bed

Effect of Babicity on Sinter Quality in Shigang

Effect of Different Basicity on Quality of Vanadium Titanium Sintering Ore

Experimental Investigation and Numerical Modeling of Strength Properties of Iron Ore Sinter Based on Pilot-Scale Pot Tests and X-ray Computed Tomography