Abstract:The degree of homogeneity of the sintered ore phase structure directly determines its quality index. A sinter ore quality evaluation method based on the quantification of the homogeneity of the mineral phase structure is proposed. First, the magnetite particle size characteristics in the ore phase structures with different degrees of homogeneity were summarized under a polarized light microscope, and a criterion for evaluating the uniformity of the sintered ore phase structure based on the magnetite content of different particle size grades was determined. Second, a multiple regression model was established for the raw material composition ratio of magnetite with varying particle size grades. Finally, the multiple regression model was optimized using the second-generation non-dominated sorting genetic algorithm (NSGA2). The results show that mineral phase structure analysis categorized the magnetite particle sizes into 60 μm. The adjusted R2 of the multiple regression model of the chemical composition of raw materials and the proportion of magnetite of each particle size grade were all greater than 0.95, and the p values were all < 0.05, indicating a high degree of model fitting. Using model analysis, the single factor and the interaction between the multiple factors that significantly influence the proportion of magnetite in the three particle size grades were determined. The multivariate regression model was optimized using the NSGA2 algorithm to determine the ratios of Al2O3 mass% = 1.82, MgO mass% = 1.50, and R(CaO mass%/SiO2 mass%) = 1.84 for the highest degree of uniformity of the sintered ores. Under this sintering condition, the micro-mineral phase structure became more homogeneous, confirming the model's reliability.

Study on Fractal Characteristics of Grain Size Distribution of Low Silica Sinter

FRACTAL STUDY ON AGGREGATION OF COLLOIDAL SILICA PARTICLES

Study on Influence of Air Distribution in Sintering Process on Sinter Quality

Influence of SiO2 addition on the sintering behavior and kinetics of fine-sized α-Al2O3 nanoparticles

Study on Influencing Factors of High-Temperature Basic Characteristics of Iron Ore Powder and Optimization of Ore Blending

Monte-Carlo simulation of isotropic and anisotropic grain growth in liquid phase sintered ceramics

The effects of packing structure on the effective thermal conductivity of granular media: A grain scale investigation

Fractal Dimension of Concrete Incorporating Silica Fume and Its Correlations to Pore Structure, Strength and Permeability

A quantitative model to understand the microflow-controlled sintering mechanism of metal particles at nanometer to micron scale

Effect of Grain Size on Microscopic Pore Structure and Fractal Characteristics of Carbonate-Based Sand and Silicate-Based Sand

Experimental Study On Crushing Strength And Young'S Modulus Of Granules In Iron Ore Sintering Using Taguchi Method

The Effect of Particle Distribution to the Sintering Properties of Al2o3 Ceramic Formed by Stereolithography

The Study of Low-Temperature Sintered Z-Type Hexaferrites

Erosion of BF slag to different Z-value β-sialon and the fractal dimension of reaction interface

Erosion of BF slag to different Zeta value beta Sialon and the fractal dimension of reaction interface

Experimental Study on Melt and Flow Characteristics and Pore Structure of Iron Ore

Experimental Investigation and Numerical Modeling of Strength Properties of Iron Ore Sinter Based on Pilot-Scale Pot Tests and X-ray Computed Tomography

A Quantitative and Optimization Model for Microstructure Uniformity of Sinter Based on Multiple Regression-NSGA2

Comparison and research of grain size measurement of ultrafine powder

Ultra-uniform Nanocrystalline Materials via Two-Step Sintering

On the Grain Size Distribution of MnO Doped ZnO Ceramics