Abstract:The effect of 3.6 vol.% WC addition to ZrB2‐20 vol.% SiC (ZSW) on oxidation resistance is studied over a broad range of oxidation temperatures, 1000‐1800 °C. Non‐WC‐containing samples (ZS) show significant surface damage and degradation during oxidation, losing protective B2O3 and SiO2‐based surface layers, exposing a porous ZrO2 layer and base material for further oxidation. ZSW samples preserve their surface protective layers during oxidation up to 1800 °C while the underlying ZrO2 scale remains dense. We report the appearance of convection cells on the surface of ZSW samples during oxidation above 1600 °C. This confirms the presence of boron‐rich phases, suppressing oxygen permeation into material, enhancing oxidation resistance of ZSW samples above. During exposure of the samples to 1800 oC for 15 min, ZS and ZSW samples gained 11.1 ± 1.5 and 7.8 ± 0.3 mg cm‐2, respectively, due to oxidation. Exposure of the composites for 5 hours at 1600 oC resulted in weight gains of 10.5 and 7.0 mg cm‐2 for ZS and ZSW samples, respectively. Cross‐sections of oxidized samples at 1800 °C show a tight zirconia layer below a glassy surface in ZSW and complete loss of surface glass in ZS, demonstrating the effectiveness of WC addition. This article is protected by copyright. All rights reserved.

High‐Temperature Oxidation at 1900°C of ZrB2–xSiC Ultrahigh‐Temperature Ceramic Composites

Oxidation behavior of zirconium diboride–silicon carbide at 1800°C

High-temperature Oxidation Behavior of Monolithic Zr3[Al(Si)]4C6 and Its Composite Incorporating 30vol% ZrB2-SiC: Providing a Basis for Broadening the Service Temperature

Oxidation Behavior of ZrB2–SiC–ZrO2 Ceramic Composites in the Temperature Range of 800–1200°C

Oxidation-resistant ZrB2–SiC composites at 2200°C

Oxidation Kinetics of Hot-Pressed ZrB2–SiC Ceramic Matrix Composites

Oxidation Behavior of ZrC-based Composites in Static Laboratory Air Up to 1300 °C

Isothermal Oxidation of Zr2[Al(Si)]4C5–SiC Composites at 1000–1300°C in Air

Oxidation of ZrC-30vol% SiC composite in air from low to ultrahigh temperature

Design and Preparation of an Ultra-High Temperature Ceramic by In-Situ Introduction of Zr2[Al(Si)]4C5 into ZrB2-SiC: Investigation on the Mechanical Properties and Oxidation Behavior

Structure Evolution of ZrB2–SiC During the Oxidation in Air

Oxidation Resistance of Zr2(Al(Si))4C5-based Composites at Ultra-High Temperature

Effect of SiC Content on the Ablation and Oxidation Behavior of ZrB2-Based Ultra High Temperature Ceramic Composites

High-Temperature Oxidation Resistance of ZrB2-SiC Ceramic Composites Prepared by Reactive Hot Pressing

Oxidation Properties of ZrB2-20vol.%SiC-10vol.%BN Ceramic Composite at 1200°C

Enhanced Oxidation Resistance of ZrB2‐SiC‐WC Composite Below 1800 °C

Oxidation Behaviour of C–SiC–ZrC Composite

Oxidation Behavior of Hot Pressed ZrB2‐ZrC‐SiC Ceramic Composites

Effect of boronizing treatment on the oxidation resistance of Zr2(AlSi)4C5/SiC composite

Oxidation Resistance Behavior of Short Carbon Fiber Reinforced ZrB2,-SiC Composites

Oxidation Resistance Performance of ZrB_2-SiC Ceramic Matrix Composites