Abstract:Despite significant efforts to develop ultra-high temperature ceramics, the phase stability together with high hardness and oxidation resistance remains to be addressed in ZrB2-SiC based ceramics. ZrB2-20 vol% SiC (ZS20) ceramics with varying amounts of Si3N4 (2.5, 5 and 10 vol%) were processed by multi stage Spark Plasma Sintering (SPS) over a range of temperature (1800–1900 °C) for 3 min under 50 MPa. All the ZS20-Si3N4 composites could be densified to more than 98% theoretical density (ρth) after SPS at 1900 °C. The XRD, SEM-EDS analysis of the ZS20-Si3N4 composites revealed the presence of reaction product phases (ZrO2, BN, ZrN) along with SiC and ZrB2 major phases. Sintering reactions were proposed to explain the existence of such new phases and extinction of Si3N4. Thermo-Calc software was also used to further confirm the formation of these new phases in the ZS20-Si3N4 samples. The hardness of ZS20-Si3N4 composites varied between 25.50 and 30.56 GPa, in particular, ZrB2-20 vol% SiC-5vol% Si3N4 measured with the maximum hardness. In fact, it is the highest ever reported hardness for the ZrB2 composites. Considering oxidation resistance, the weight gain of ZrB2-20 vol%SiC composites decreased (from 13.84 to 9.84 mg/cm2) and oxide layer thickness increased (64–128 μm) after oxidation at 1500 °C for 10 h in air. The cross sectional microstructure of oxidized ZS20-Si3N4 composites consists of thick dense outer layer of SiO2, intermediate (ZrO2-SiO2) layer and unreacted bulk. The formation of dense SiO2 layer and absence of SiC depleted layer from the oxidized samples are signatures of improved oxidation resistance of Si3N4 reinforced ZrB2-20 vol% SiC.

Oxidation Properties of ZrB2-20vol.%SiC-10vol.%BN Ceramic Composite at 1200°C

High temperature oxidation resistance of hot-pressed h-BN/ZrO 2 composites

Oxidation Kinetics of Hot-Pressed ZrB2–SiC Ceramic Matrix Composites

Oxidation Behavior of ZrB2–SiC–ZrO2 Ceramic Composites in the Temperature Range of 800–1200°C

Oxidation Behavior of ZrC-based Composites in Static Laboratory Air Up to 1300 °C

Oxidation Behavior of Hot Pressed ZrB2‐ZrC‐SiC Ceramic Composites

Oxidation Behaviors of the Pressureless Sintered ZrB<SUB>2</SUB>-SiC Composites: Oxidation Behaviors of the Pressureless Sintered ZrB<SUB>2</SUB>-SiC Composites

High-Temperature Oxidation Resistance of ZrB2-SiC Ceramic Composites Prepared by Reactive Hot Pressing

Oxidation Behaviour of C–SiC–ZrC Composite

High‐Temperature Oxidation at 1900°C of ZrB2–xSiC Ultrahigh‐Temperature Ceramic Composites

Preparation, Microstructures, Mechanical Properties and Oxidation Resistance of SiBCN/ZrB2–ZrN Ceramics by Reactive Hot Pressing

Oxidation-resistant ZrB2–SiC composites at 2200°C

Oxidation Resistance Performance of ZrB_2-SiC Ceramic Matrix Composites

Oxidation Resistance Behavior of Short Carbon Fiber Reinforced ZrB2,-SiC Composites

Design and Preparation of an Ultra-High Temperature Ceramic by In-Situ Introduction of Zr2[Al(Si)]4C5 into ZrB2-SiC: Investigation on the Mechanical Properties and Oxidation Behavior

Oxidation Behaviors of C–ZrB2–SiC Composite at 2100 °C in Air and O2

Phase stability, hardness and oxidation behaviour of spark plasma sintered ZrB2-SiC-Si3N4 composites

Oxidation Behavior of Sic Platelet-Reinforced Zrb2 Ceramic Matrix Composites

High-temperature Oxidation Behavior of Monolithic Zr3[Al(Si)]4C6 and Its Composite Incorporating 30vol% ZrB2-SiC: Providing a Basis for Broadening the Service Temperature

Effect of atomic oxygen on oxidation behavior of ZrB2-SiC ceramic composite materials

Oxidation Behavior of SiBCN-Zr Composites at 1500 °C Prepared by Reactive Spark Plasma Sintering