Abstract:Multilevel inverters typically require a large number of power switches, increasing the likelihood of faults and compromising system reliability. To enhance inverter reliability, this article introduces a five-level multilevel inverter with fault-tolerant capabilities. This topology employs two DC voltage sources with four unidirectional and two bidirectional power IGBT switches. A fault-tolerant control strategy has been developed to reconfigure the topology whenever an open circuit fault occurs in a switch. To evaluate the proposed topology, a loss analysis and efficiency assessment were conducted using Piecewise Linear Electrical Circuit Simulation. The results showed 36.35 W of power loss and an efficiency of 96.49% for 1 kW of output power. The total standing voltage per unit and cost function of the proposed topology are 6 and 4.2, respectively, which are minimal compared to other fault-tolerant topologies. Furthermore, a laboratory prototype was developed using a DSPACE-1202 controller to validate the results. The voltage stress on the power devices was found to be reduced by 25–50% under various post-fault conditions compared to healthy condition. The proposed topology is able to withstand OC fault in single unidirectional switch or multiple unidirectional switches and still be able to generate 64% of the rated output rms voltage. If an OC fault occurs in any of the bidirectional switches, then the topology is fully tolerant by generating 100% of the rated output rms voltage. The reliability for the proposed topology is performed using Markov chain rule and proved that the proposed topology is superior to other topologies.

Reconfiguration of Carrier-Based Modulation Strategy for Fault Tolerant Multilevel Inverters

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

A fault-tolerant T-type three-level inverter system

Recovering Partial Three-Level Operation in a T-Type Inverter with Fault Management Redundant Unit

A Redundant Unit to Form T-Type Three-Level Inverters Tolerant of IGBT Open-Circuit Faults in Multiple Legs

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

A Single-Phase Multilevel Inverter Topology with Fault Tolerant Capability for Single and Multiple Switch Failures

Multicarrier PWM Strategies for Hybrid Symmetrical Multilevel Inverter with Reduced Switch Count

Fault-Tolerant Control Of Cps-Pwm-Based Cascaded Multilevel Inverter With Faulty Units

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

Fault-tolerant design for flying capacitor multilevel inverters

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

A Multilevel Converter Topology with Fault-Tolerant Ability

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

Control method for cascaded H-bridge multilevel inverter with faulty power cells

A Unified Fault Tolerant Control and Neutral-Point Voltage Balance Strategy for Three-Level T-Type Inverters under Double Signal PWM

A Fault-Tolerated Control Strategy for Sub-Module Faults of Modular Multilevel Converters

A Fault-Tolerant Control Strategy for Three-Level Grid-Connected NPC Inverters after Single-Arm Failure with Optimized SVPWM

Novel Carrier-Based Pwm Methods for Multilevel Inverter

Modified Hybrid Modulation Scheme with Even Switch Thermal Distribution for H-Bridge Hybrid Cascaded Inverters