Abstract:This paper presents a new fault‐tolerant reduced switch count topology to mitigate reliability issues caused by switch failures in conventional multilevel inverter systems. A reduced number of switches and minimum control complexity make the suggested topology suitable for fault tolerance during single and multiple open‐circuit switch failures. Both symmetric and asymmetric designs are assessed for fault‐tolerant operation in normal, faulty, and post‐fault scenarios. This work exhibits the added reliability and compatibility of the proposed system for industrial applications that need high reliability. Reliability is a major concern in multilevel inverters (MLI) due to the increased number of power switches and diodes, which increases the chance of switch failures and complicates the inverter design. The primary challenges faced by the current MLI design include higher control complexity, increased parasitic elements, more extensive protection, and lack of multiple fault tolerance. Therefore, developing reduced switch MLI with fault‐tolerant ability is crucial to ensure system availability and prevent adverse outcomes. To address these challenges, this article introduces a highly resilient fault‐tolerant reduced switch count (FTRSC) MLI topology offering fault tolerance with minimal switch count. The proposed topology provides fault tolerance in case of single‐ and multiple‐switch open‐circuit (OC) failures. The inherent fault‐tolerant operation is analyzed for the proposed topology's symmetric and asymmetric configurations. The simulation and experimental results validate the effectiveness of the proposed topology considering normal, faulty, and postfault conditions. Furthermore, the reliability evaluation of the proposed work is carried out using the Markov chain model, resulting in a high total mean time to failure of approximately 117,550 h/failures, along with an efficiency of 96.3%. These findings demonstrate that the proposed circuit has enhanced reliability and extended mean time to failure, affirming its suitability for sensitive industrial applications. Finally, a thorough comparison with recent studies highlights the superiority of the proposed system.

Fault-tolerant design for flying capacitor multilevel inverters

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

A fault-tolerant T-type three-level inverter system

Switched-capacitor Multilevel Inverter with Self-Voltage-balancing for High-Frequency Power Distribution System

A novel multilevel inverter topology with no clamping diodes and flying capacitors

A Redundant Unit to Form T-Type Three-Level Inverters Tolerant of IGBT Open-Circuit Faults in Multiple Legs

A Single-Phase Multilevel Inverter Topology with Fault Tolerant Capability for Single and Multiple Switch Failures

Reconfiguration of Carrier-Based Modulation Strategy for Fault Tolerant Multilevel Inverters

A Multilevel Converter Topology with Fault-Tolerant Ability

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

Enhancing Reliability in Multilevel Inverter: A Fault‐Tolerant Approach With Reduced Switch Count

Recovering Partial Three-Level Operation in a T-Type Inverter with Fault Management Redundant Unit

Modeling Of Five-Level Symmetric Flying Capacitor Multilevel Inverter For Statcom Application

A novel hybrid flying-capacitor-half-bridge cascade 13-level inverter for high power applications

A single-input extended multilevel inverter based on switched-capacitor with reduced number of devices

Evaluation of Symmetric Flying Capacitor Multilevel Inverter for Grid-Connected Application

Self-balanced switched-capacitor multilevel inverter with asymmetric double-wing structure

Capacitor Voltage Balancing Control of A Flying Capacitor Based N-Level Dc-Dc Converter

Analysis and control of fault tolerant operation of five-level ANPC inverters

A Novel Cascaded Multilevel Inverter Topology

Seventeen-Level Inverter Based on Switched-Capacitor and Flying-Capacitor-Fed T-type Unit