Abstract:A thermoplastic, poly(ethersulfone) (PES) was used to modify a bisphenol-F based epoxy resin cured with an aromatic diamine. The initial mixtures before curing, prepared by melt mixing, were homogeneous. Scanning electron microscopy (SEM) micrographs of solvent-etched fracture surfaces of the cured blends indicated that phase separation occurred after curing. The cryogenic mechanical behaviors of the epoxy resins were studied in terms of tensile properties and Charpy impact strength at cryogenic temperature (77 K) and compared to their corresponding behaviors at room temperature (RT). The addition of PES generally improved the tensile strength, elongation at break, and impact strength at both RT and 77 K except the RT tensile strength at 25 phr PES content. It was interesting to observe that and the maximum values of the tensile strength, elongation at break, and impact strength occurred at 20 phr PES content where a co-continuous phase formed. Young's modulus decreased slightly with the increase of the PES content. Moreover, the tensile strength and Young's modulus at 77 K were higher than those at RT at the same composition, whereas the elongation at break and impact strength showed the opposite results. Finally, the differential scanning calorimetry analysis showed that the glass transition temperature (T-g) was enhanced by the addition of PES. (C) 2007 Wiley Periodicals, Inc.

Influence of Attapulgites on Cure‐reaction‐induced Phase Separation in Epoxy/poly(ether Sulfone) Blends

Polymerization-induced viscoelastic phase separation in polyethersulfone-modified epoxy systems.

Study on the Polyethersulfone/bismaleimide Blends: Morphology and Rheology During Isothermal Curing

Polymerization-induced phase separation in polyethersulfone modified epoxy resin systems: effect of curing reaction mechanism

Effect Of Polyethersulfone On The Mechanical And Rheological Properties Of Polyetherimide-Modified Epoxy Systems

Rheological Study of Epoxy Systems Blended with Poly(ether sulfone) of Different Molecular Weights

Viscoelastic Effects on the Phase Separation in Thermoplastics-Modified Epoxy Resin

Effect Of Attapulgite Nanorods And Calcium Sulfate Microwhiskers On The Reaction-Induced Phase Separation Of Epoxy/Pes Blends

Rheological Behaviors and Structural Transitions in A Polyethersulfone-Modified Epoxy System During Phase Separation

Studies on the Phase Separation of Poly(Ether Imide)‐Modified Cyanate Ester Resin

Effect of epoxidized polybutadiene-b-polystyrene on the reaction induced phase separation behavior of poly(phenylene oxide) modified epoxy blends

Studies on the viscoelastic phase separation in epoxy resin modified with polyethersulfone

Preparation and Cryogenic Mechanical Properties of Epoxy Resins Modified by Poly(ethersulfone)

A DSC Study of Miscibility and Phase Separation in Crystalline Polymer Blends of Phenolphthalein Poly(ether Ether Sulfone) and Poly(ethylene Oxide)

Thermal Stabilities and Mechanical Interfacial Properties of Polyethresulfone-Modified Epoxy Resin

Numerical simulation of phase separation processes of polyethersulfone-epoxy resin blend systems

Studies on Phase Separation of Polyesterimide-Modified Epoxy Resin. Ii. Effect of Curing Temperature on Phase Separation and Adhesive Property

Studies on Phase Morphology Control of Epoxy/PSF Blends

Gelation Behavior of Thermoplastic-Modified Epoxy Systems During Polymerization-Induced Phase Separation

Phase Morphology and Mechanical Properties of a Poly(ether Sulfone)‐modified Bismaleimide Resin

Polymerization-induced Phase Separation in Polyether-Sulfone Modified Epoxy Resin Systems: Effect of Curing Reaction Mechanism