Abstract:This paper studies the phase separation in poly(ether imide) (PEI) modified epoxy resin using imidazole (C11Z-CNS) as epoxy hardener to control its morphology. The sponge-like phase structures were founded at higher PEI concentration (10–25phr), while homogeneous structures are formed at low PEI concentration (5phr). The effects of PEI concentration on curing kinetics and phase structures were studied by differential scanning calorimeters (DSC) and scanning electron microscopy (SEM). It is shown that although the addition of PEI does not change the curing mechanism, the separated morphology becomes finer at high PEI concentration. The curing rate and conversion decrease with the increase of the content of PEI. The chain growth polymerization of these systems caused an early gelation (conversion <10%) and early freezing of morphologies. The evolution of phase separation in the early stage was monitored by synchrotron radiation small angle X-ray scattering (SR-SAXS) and transmission electronic microscopy (TEM). It is suggested that the formation of sponge-like phase structure could be attributed to the strong viscoelastic effects in the early stage of phase separation.

Studies on the Phase Separation of Poly(Ether Imide)‐Modified Cyanate Ester Resin

Viscoelastic Effects on the Phase Separation in Thermoplastics Modified Cyanate Ester Resin

Morphology and mechanical properties of poly(ether-imide)-modified polycyanurates

Polymerization Induced Phase Separation in Poly(ether Imide)-Modified Epoxy Resin Cured with Imidazole

Effect Of Polyethersulfone On The Mechanical And Rheological Properties Of Polyetherimide-Modified Epoxy Systems

Viscoelastic Effects on the Phase Separation in Thermoplastics-Modified Epoxy Resin

Study on the Polyethersulfone/bismaleimide Blends: Morphology and Rheology During Isothermal Curing

Further Study of the Viscoelastic Phase Separation of Cyanate Ester Modified with Poly(ether Imide)

Studies on the Phase Separation of Poly(ether Imide)modified Tetrafunctional Epoxy Resin——The Effect of Curing Agent Ratio

Kinetics of Phase Separation at the Early Stage of Spinodal Decomposition in Epoxy Resin Modified with PEI Blends

Polymerization-induced viscoelastic phase separation in polyethersulfone-modified epoxy systems.

Studies on the Phase Separation of Polyetherimide-Modified Epoxy Resin, 3. Morphology Development of the Blend During Curing

Studies on the phase separation of polyetherimide-modified epoxy resin, 3 - Part 1 - Morphology development of the blend during curing

Studies on Phase Separation of Polyesterimide-Modified Epoxy Resin. Ii. Effect of Curing Temperature on Phase Separation and Adhesive Property

Studies on the phase separation of polyetherimide-modified epoxy resin, 1. Effect of curing rate on the phase structure

Studies on the Phase Separation of Polyetherimide Modified Tetrafunctional Epoxy Resin. Ii. Effects of the Molecular Weight

Studies on the Phase Separation of Poly(ether imide)-Modified Epoxy Resin, 5. Phase Separation Behavior of a Quasi-Binary System

Thermal and Mechanical Evaluation of Cyanate Ester Resin Modified with Bismaleimide and Diallyl Phthalate

Studies on the Phase Separation of Polyetherimide‐modified Epoxy Resin, 2. Effect of Molecular Weight of PEI on the Structure Formation

Phase Morphology and Mechanical Properties of a Poly(ether Sulfone)‐modified Bismaleimide Resin

Studies on the Phase Separation of a Polyetherimide-Modified Epoxy Resin, 4. Kinetic Effect on the Phase Separation Mechanism of a Blend at Different Cure Rates