Abstract:Reactive powder concrete (RPC) is an ultra-high performance concrete (UHPC) with an enhanced microstructure. Over the past few years, the demand for RPC has increased due to its superior properties. However, RPC is characterized by its low water-to-binder ratio, high cement and silica fume (SF) content, and absence of coarse aggregates which not only harm sustainable development, but also increase the production costs of RPC and generate shrinkage problems. Within this framework, many studies attempted to use different materials to address these problems and produce eco-friendly RPC with similar performance to that of the traditional RPC. The primary objective of this paper is to present an updated review of the literature on the list of materials used for RPC production and assess their viability as partial and full replacement of cement, SF, and quartz sand/powder to produce ultra-high strength RPC. The effects of employing different curing regimes and mixing procedures on the compressive strength of RPC will also be reviewed. The results highlight that 1) the use of alternative mineral admixtures (glass powder, limestone & phosphorous slag) can successfully replace cement by up to 50%; 2) replacing SF with mineral admixtures such as slag and fly ash is possible and can yield comparable results by monitoring the molar Ca/Si ratio of the mixes; 3) Quartz sand/powder can successfully be replaced with other types of aggregates/fillers (titanium slag, glass sand, glass powder, rice husk ash, etc); 4) Waste steel fibers can yield comparable strength results to that of steel fibers and the hybridization of glass-steel and polypropylene-steel improves the strength compared to steel or other types alone; and 5) Four-stage mixing yields better strength properties (up to 22% enhancement) compared to three-stage mixing, but further research is required to confirm this finding and establish standard guidelines for the mixing of RPC.

Size Effect on Strength of Ultra-high Strength Concrete RPC

Experimental Research the Shearing Performance of Grading-Fiber Reinforced Reactive Powder Concrete

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Experimental Study on the Spalling Strength of Fiber Reactive Powder Concrete

Experimental investigation on the dynamic tensile behavior of graded steel-fiber RPC

Ultra high performance concrete RPC under compressive impact loading

Composition of reactive powder concretes

Size Effect On The Cubic Compressive Strength Of Reactive Powder Concrete

Experiment and Analysis of Local Compression Bearing Capacity of Reactive Powder Concrete

Impact of using different materials, curing regimes, and mixing procedures on compressive strength of reactive powder concrete - A review

Optimization of alkali-activated binder reactive powder concrete based on concept of packing density

Investigation on size effects of ultra-high-performance concrete: experimental and numerical study

Effect of Fibers on High-Temperature Mechanical Behavior and Microstructure of Reactive Powder Concrete

Effect of mineral admixtures on the resistance to sulfate attack of reactive powder concrete

Impact Mechanical Properties of Reactive Powder Concrete after Exposure in High Temperature

Study on Mechanical Properties and Microstructure of Basalt Fiber Reactive Powder Concrete

Experimental study on flexural toughness of different fiber RPC

Investigation of the Match Relation Between Steel Fiber and High-Strength Concrete Matrix in Reactive Powder Concrete.

Experiment and validation of local bearing capacity for reactive powder concrete confined with high-strength spirals

The Mechanical and Self-Sensing Performance of Reactive Powder Cement Concrete with Nano-Stainless Steel Powder

Experimental Research on Preparation of Reactive Powder Concrete