Abstract:This study was aimed to investigate the effect of steel, polypropylene (PP), and hybrid (steel + PP) fibers on high-temperature mechanical properties of reactive powder concrete (RPC). The mechanical properties considered are cubic compressive strength, axial or prismatic compressive strength, split-tensile strength, flexural strength, elastic modulus, peak strain, and stress-strain behavior. The strength recession due to high temperature was investigated at micro level by scanning electron microscope, energy dispersive X-ray spectroscopy, X-ray diffraction, mercury intrusion porosity, thermogravimetric, and differential scanning calorimetry analyses. The high-temperature tests were carried out at target temperatures of 120, 300, 500, 700, and 900 °C. The hot-state compressive strength of RPC started to decrease at 120 °C; however, a partial recovery at 300 °C and a gradual decrease above 300 °C were observed. The degradation of split-tensile strength, flexural strength, and elastic modulus were gradual with increasing temperature despite the effect of different fibers. Whereas, the peak strain was gradually increasing up to 700 °C. However, after 700 °C, it remained unchanged. Steel fiber reinforced RPC (SRPC) and hybrid fiber reinforced RPC (HRPC) showed a ductile behavior. PP fiber reinforced RPC (PRPC) showed a quite brittle behavior up to 300 °C; however, further heating made the microstructure porous and it became ductile too. Overall the performance of SRPC and HRPC were superior to PRPC because of higher modulus of elasticity, higher strength, and better fire resistance of steel fibers. Fiber reinforced RPC was found to have better fire resistance than traditional types of concrete based on comparative studies with the provisions of design codes and earlier research. The constitutive equations developed can be utilized in computer programs for structural design of RPC structures exposed to fire.

Experimental Research the Shearing Performance of Grading-Fiber Reinforced Reactive Powder Concrete

Experimental investigation on the dynamic tensile behavior of graded steel-fiber RPC

Experimental Study on the Spalling Strength of Fiber Reactive Powder Concrete

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Experimental Research on Composite Action of Concrete-filled RPC Tube under Axial Load

Experimental research on seismic behavior of concrete-filled reactive powder concrete tubular columns

Experimental study on flexural toughness of different fiber RPC

Influence of Rpc Grouting Materials on Shear Behavior of Wet Joints in Pcsbs with Confining Stress

Investigation of the Match Relation Between Steel Fiber and High-Strength Concrete Matrix in Reactive Powder Concrete.

Study on Mechanical Properties and Microstructure of Basalt Fiber Reactive Powder Concrete

Experiment Investigation for Dynamic Behavior of Hybrid Fiber Effects on Reactive Powder Concrete

Effect of different fibers (steel fibers, glass fibers, and carbon fibers) on mechanical properties of reactive powder concrete

Experimental Study on Mechanical Properties of Synthetic Macro-Fiber Reinforced Reactive Powder Concrete

Effect of Steel Fiber Type and Curing Regimen on the Mechanical Properties of Reactive Powder Concrete

Experiment and Analysis of Local Compression Bearing Capacity of Reactive Powder Concrete

Effect of Fibers on High-Temperature Mechanical Behavior and Microstructure of Reactive Powder Concrete

Experimental research on preparation of self-compacting RPC reinforced with fibers

Direct Shear Behavior of Castellated Dry RPC Joints in Precast Concrete Segmental Bridges

Study on the bonding performance between reactive powder concrete and steel bar

Electrically Conductive Behaviors and Mechanisms of Short-Cut Super-Fine Stainless Wire Reinforced Reactive Powder Concrete

Mechanical properties of steel fiber RPC, basalt fiber RPC, and hybrid fiber RPC: A review of research progress